673337

Medisana BS477 - 40437 Manual

24
Zoom out
Zoom in
Previous page
1/28
Next page
21
ENGLISH
5 Insert/replace batteries
Two button cell batteries (type CR2032) are already inserted in your new scale. The insulating strip
must be pulled out of the battery compartment
on the underside of the unit before the scale can
be operated. Replace the batterie if the battery change symbol "LO" appears in the display
or if
nothing appears in the display after you have stepped on the device. To do this, open the battery
compartment
beneath the device and insert two cell batteries (type CR2032). Please note polarity
(positive pole upwards; facing towards the lid). Close the battery compartment
again.
WARNING
Battery safety information
• Do not disassemble batteries!
• Clean the battery and device contacts if necessary before putting in the batteries!
• Remove discharged batteries from the device immediately!
• Increased risk of leakage, avoid contact with skin, eyes and mucous membranes! If battery acid
comes in contact with any of this parts, rinse the affected area with copious amounts of fresh
water and seek medical attention immediately!
• If a battery has been swallowed seek medical attention immediately!
• Insert the batteries correctly, observing the polarity!
• Keep the battery compartment well sealed!
• Remove the batteries from the device if it is not going to be used for an extended period!
• Keep batteries out of children's reach!
• Do not attempt to recharge these batteries! There is a danger of explosion!
• Do not short circuit! There is a danger of explosion!
• Do not throw into a fire! There is a danger of explosion!
• Keep unused batteries in their packaging away from metal objects in order to prevent short
circuiting!
• Do not throw used batteries into the household refuse; put them in a hazardous waste container
or take them to a battery collection point, at the shop where they were purchased!
6 Change the unit of weight
You may have your weight displayed in kilograms (kg), pounds (lb) or stones (st). Switch the scales on
by touching with the foot and press the
button until the desired units are displayed.
7 Weighing “Step-on”-function
1. Make sure the scales are on a firm, level surface. If you only want to weigh yourself but have moved
the scales just before, you must first initialise the scales. To do this, press your foot on the middle
of the surface of the scales. "0.0 kg" appears in the display. When the scales switch off, they are
ready for the “step-on” function. This procedure is not necessary if you have not moved the scales.
2. Step onto the scales and stand still. The device switches on automatically and the display
briefly
shows "0.0 kg".
3. Your weight is measured, flashes three times and is then finally displayed.
4. Step down from the scales. The scales switch off automatically after 12 seconds.
… 24 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Medisana BS477 - 40437 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Medisana BS477 - 40437 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 2,58 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info