498750
15
Zoom out
Zoom in
Previous page
1/70
Next page
2 Useful Information / 3 Operation
GB
9
1.
2.
3.
4.
3.1
Positioning
and setup
3 Operation
Press and hold the Set-button for about 3 seconds, until the time
in the display flashes. Adjust the time with the and buttons.
Press the Set-button again to confirm the time. After that, you may
select one of two alarm settings (AL1 or AL2) or the Zizz (short time
alarm) for adjustment with the , and buttons.
The adjustment needs to be done in the same way with the ,
and buttons as for the time adjustment. Additionally you need to
select the way of alarming: By radio (FM) or by nature sounds (Sound).
Depending on your selection you then need to adjust either the radio
frequency or one of the eight nature sounds. In the following you need to
set the volume and the light brightness level. If you only want to use the
light or sound/radio function, adjust the other function to 0.
If you do not press a button for at least 10 seconds, the device will quit
the setting mode automatically. To activate an alarm you need to press
the corresponding button (see 3.5 Activate an alarm resp. 3.6 Short time
alarm). In case an alarm is activated, the L-Mode- and S-Mode-
buttons are not available.
3.2
Setting the
time and the
alarms
With the S-Mode-button you can choose a sound source. With each
press on the button you change the source in this sequence: SOUND
(nature sounds) - FM (radio) - MPS (MP3 player) - OFF. If you have
chosen the nature sounds, you additionally need to select one of the eight
sounds with the and buttons. For listening to MP3 music, a
MP3 player with 3.5mm jack plug needs to be connected to the connector
for MP3 player and needs to be switched on. The volume can be con-
trolled with the buttons and . g
3.3
Choose the
source of
sound
(S-Mode)
Place the device on a solid and flat surface for use to ensure that it
cannot tip over or fall down. G
Position the device about 40 - 50 cm away from your head, for exam-
ple on a bedside table. G
Plug the cable antenna to the the connector for cable antenna on
the rear side of the device. G
Plug the mains cable end to the connector for power cable on the
rear side of the device and the power adapter to the wall outlet. G
The packaging can be reused or recycled. Please dispose properly of any
packaging material no longer required. If you notice any transport damage
during unpacking, please contact your dealer without delay. G
Please ensure that the polythene packing is kept away from the
reach of children! Risk of suffocation!
WARNING
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Medisana 45105 - WL 450 WAKE-UP LIGHT at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Medisana 45105 - WL 450 WAKE-UP LIGHT in the language / languages: English, German, Dutch, French, Italian, Portuguese, Swedish, Spanish, Finnish as an attachment in your email.

The manual is 6,41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info