531795
26
Zoom out
Zoom in
Previous page
1/168
Next page
10. Troubleshooting
Problem Solution
If the motor
is not running
Check presence of mains current.
Check the position of the batteries in the battery compartment.
If there is low
or no suction
Verify the valve head and membrane are clean and not damaged.
Ensure the membrane is attached correctly to the valve head.
Check the lateral position of the valve.
Check all connections.
Check the ends of the tubing t securely into the back of the
connector and into the port on the breastpump.
Do not kink the tubing during expression.
Ensure the breastshield forms a complete seal around the breast.
If condensation
appears in
the tubing
Rinse out the tubing.
Shake out any water droplets.
Hang up the tubing to air-dry.
If milk gets
into the tubing
Turn off the pump and unplug from power source.
Remove and clean the tubing.
Shake out water droplets and hang to air-dry.
If milk gets
into the pump
Turn off the pump and unplug from power source.
1. Open the battery cover, remove the expanded-plastic liner. Wash
the expanded-plastic liner with clear, lukewarm water and squeeze
out well. Allow to dry thoroughly.
2. Pour about 200 ml of warm soapy water into a container.
3. Connect the tubing and the power cable onto the pump.
4. Hold the device with the control button upwards over a basin and
switch on. Press and ensure that the lowest vacuum level is
set by pressing twice.
5. Hold the end of the tubing that is not connected to the pump in
the container with the soapy water.
6. The water is pumped through the tubing into the device.
Allow it to pump until all the water has been ushed through.
7. Repeat procedure with 100 ml of clear, warm water.
8. Then leave the device switched on for 3 minutes, until the pump
is completely dry.
9. As soon as the expanded-plastic liner is dry, put it in place again
and close the battery cover.
10. If necessary, clean the pump set according to cleaning instruc-
tions „Prior to rst use and once daily“.
2626
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Medela Swing at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Medela Swing in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 11,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info