807157

Meaco Heat MotionMove Eye 2.0kW Manual

3
Zoom out
Zoom in
Previous page
1/7
Next page
3 [EN]
the heater on. Do not allow oil, grease, or other contaminants to be drawn into the heater. Do not clean the heater
with organic solvents.
14. Never unplug the power cord without pressing the "ON/OFF" button first, as this could damage the unit. Never
unplug the heater before the fan has stopped blowing. Always unplug the unit when not in use or moving location.
To disconnect from the power supply, grip the plug and pull from the power socket. Never pull by the cord.
15. Keep Electrical Components Dry: Never allow water inside the heater's electrical components. If these areas become
wet for any reason, thoroughly dry them before using the heater. If in doubt do not use the heater and consult a
qualified electrician or a Meaco approved engineer.
16. The operator must make the operating instruction available for the user and make sure that the user does understand
the manual.
17. To repair the unit, take it to a qualified service engineer. Repairs carried out by unqualified people may cause damage
to the unit or injury to persons or property and void the warranty.
ATTENTION: The heater is fitted with a thermal cut out and a tip-over switch
so if the heater starts to overheat or if it falls over then it will automatically turn
off.
UK PLUG WIRING
Wiring Instructions: Should it be necessary to change the plug please note the wires in the mains
lead are coloured in accordance with the following code:
BLUE - NEUTRAL
BROWN – LIVE
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows:
1. The BLUE wire is the NEUTRAL and must be connected to the terminal that is marked with the letter N or
coloured BLACK.
2. The BROWN wire is the LIVE and must be connected to the terminal that is marked with the letter L or coloured
RED.
3. Always ensure that the cord grip is positioned and fastened correctly.
If a 13A (BS 1363) fused plug is used it must be fitted with a 13A (BS 1362) fuse. If in doubt consult a qualified
electrician.
Wiring for a 13 Amp Plug (BS 1363)
1. GENERAL ADVICE
Before putting your heater into operation for the first time, the instruction manual should be studied carefully.
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Meaco Heat MotionMove Eye 2.0kW at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Meaco Heat MotionMove Eye 2.0kW in the language / languages: English as an attachment in your email.

The manual is 0.77 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info