4 [EN]
Control Panel
---------------------------------------------------------------------------------------------------------------------------------------
Please note all the buttons are touch sensitive and bleep when pressed. The buttons need to be pressed quickly,
do not hold your finger on the button for longer than one second (unless when turning the air circulator ON/OFF,
see below). Do not operate the controls on the base of the air circulator with your feet.
Power
When plugged in the air circulator will bleep once and display the room temperature
on the display, this is standby mode. To turn the air circulator on put your finger on
the power button for two seconds. The air circulator will bleep and start to operate.
To turn the air circulator off, put your finger on the power button again for two
seconds, you will hear a longer bleep and the air circulator will slow down and stop.
Mode
Press the mode button to move through the four modes: normal, natural, sleep and
ECO.
Normal mode: This is the default setting on the air circulator. The fan speed can
be adjusted between 1 and 12. The airflow is constant on each fan speed.
Natural mode: Press the mode button once to reach natural mode – the symbol to
the left will appear on the display. The fan speed can be adjusted between 1 and
12. The airflow will alternate between weak and strong in order to replicate a natural
breeze.
Sleep mode: Press the mode button twice to reach sleep mode – the symbol to the
left will appear on the display. The fan speed will decrease by one level every 30
minutes. When fan speed 1 has been reached, the fan will continue to run until it is
manually turned off.
ECO mode: Press the mode button three times to reach ECO mode - the room
temperature will appear on the display. In ECO mode the fan speed will
automatically change as per the table on the following page.
