Power
When plugged in the fan will bleep once and display the room temperature on the
display, this is standby mode. To turn the fan on press the power button. The fan
will bleep and start to operate. To turn the fan off press the power button again, you
will hear a longer bleep and the fan will slow down and stop.
Speed
Press the speed button to adjust the air flow fan speed. There are 12 fan speeds
available. As long as the fan remains plugged in, the fan will remember the last fan
speed used. The speed can be adjusted on the control panel or via the remote
control.
Vertical and horizontal oscillation
Press the oscillation buttons to start and stop the sideways oscillation left and right
or up and down. Press the button once to turn the oscillation on and press the button
again to stop the motion, in doing so you can fix the direction of the fan.
Timer
When the fan is in standby mode use the timer button to set an interval, in one-hour
segments, between 1 and 12 hours after which the fan will turn ON. Once you have
reached the desired number of hours on the display the number will flash four times
and then set.
When the fan is turned on and running, use the timer button to set an interval, in
one-hour segments, between 1 and 12 hours after which the fan will turn OFF. Once
you have reached the desired number of hours on the display the number will flash
four times and then set.
To turn the timer off, press the timer button until 00 is displayed.
Eco
Press the ECO button to turn ECO mode ON/OFF. In ECO mode the fan speed will
automatically change as per the table on the following page. The room temperature
will appear on the display.
