Manual MCZ Sagar Air 2011 (page 62 of 65) (English)

694361

Zoom out

Zoom in

1/65

PELLET STOVES Chapter 6

INSTALLATION AND USE MANUAL

page 62

Problems/ causes/ solutions Technical service - Rights reserved MCZ Group S.p.A. - Reproduction prohibited

9. PROBLEMS / CAUSES / SOLUTIONS

ATTENTION:

All repairs must be carried out exclusively by

a specialised technician, with the stove

completely cold and the electric plug pulled

out.

PROBLEM POSSIBLE CAUSES REMEDY

Pellets not being fed

into the combustion

chamber.

 Pellet hopper empty.

 Feeder screw blocked by sawdust.

 Reduction motor defective.

 Defective electronic board.

 Refill pellet hopper.

 Empty the hopper and manually free the

feeder screw of sawdust.

 Replace reduction motor.

 Replace electronic board.

The fire goes out or the

stove stops

automatically.

 Pellet hopper empty.

 Pellets not being fed in.

 Intervention of pellet temperature sensor.

 Door not closed properly or gaskets

worn.

 Unsuitable pellets.

 Low pellet feed rate.

 Combustion chamber dirty.

 Smoke outlet obstructed.

 Smoke extraction motor failed.

 Refill pellet hopper.

 See previous problem..

 Let the stove cool down completely, reset

the thermostat till lockout ceases, relight

stove; if problem persists, contact

technical assistance.

 Close the door

or replace the gaskets

with original spare parts.

 Change to a type of pellet recommended

by the manufacturer.

 Have the fuel feed rate checked by

technical service.

 Clean the combustion chamber, following

instructions in the manual.

 Clean the smoke duct.

 Check the motor and replace if

necessary.

The stove runs for a

few minutes and then

goes out.

 Lighting cycle not completed.

 Temporary failure of electricity supply.

 Smoke duct obstructed.

 Temperature sensors defective or broken.

 Sparkplug failure.

 Re-run lighting cycle.

 See previous instruction.

 Clean smoke duct.

 Check and replace sensors as

necessary.

 Check the plug and replace if

necessary.

Pellets build up in

grate, door glass gets

dirty and flame is weak.

 Insufficient combustion air.

 Pellets damp or unsuitable.

 Smoke extractor motor broken.

 Check that the room air intake is present

and free.

 Check that the combustion air filter on the

pipe Ø 5 cm for air inlet is not obstructed.

 Clean the grate and check that all the

airways are clear.

 Carry out a general cleaning of the

combustion chamber and the smoke duct.

 Check the state of the door gaskets.

 Change the type of pellet.

 Check the motor and replace if

necessary.

Downloaded from www.Manualslib.com manuals search engine

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of MCZ Sagar Air 2011 in the language / languages: English as an attachment in your email.

The manual is 4,32 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

MCZ Sagar Air 2011 Manual

Product: