812444
16
Zoom out
Zoom in
Previous page
1/32
Next page
16
15-ALARMS
ALARM SIGNALLING
When an operating condition other than the one expected for regular stove operation occurs, an alarm is triggered.
The reason for the alarm is shown on the control panel. The sound signal is not enabled for alarms A01-A02 in order not to disturb the user
when there is an absence of pellets in the hopper during the night.
Panel signalling Type of problem Solution
A01
FAILED IGNITION
The ame does not ignite Check the level of pellets in the hopper.
Check that the brazier is correctly positioned in its seat
and has no deposits or unburnt material.
Make sure the glow plug warms up.
Thoroughly empty and clean the brazier before
restarting.
A02
NO FLAME
The re goes out abnormally. Check the level of pellets in the hopper.
A03
Thermostat alarm
The temperature of the pellet hopper exceeds
the required safety threshold.
Wait until the end of the cooling stage, stop the alarm
and re-ignite the stove setting the supply of fuel to
minimum (SETTINGS menu - Pellet recipe). If the
alarm persists, contact the service centre.
Check whether the room fan is working correctly.
A04
SMOKE OVERTEMPERA
TURE
Smoke overtemperature. Reduce the load of pellets (SETTINGS menu - Pellet
recipe). Check cleaning of the brazier
A05
Safety devices alarm
Smoke pressure switch triggered Check for chimney obstructions / door open
Fuel loading hatch Close the hatch.
Lower the fuel level in the hopper.
Open stove door Close the door
A08
FUMES MOTOR FAULT
Anomalous operation of smoke fan. Cancel the alarm and turn the stove on again. If the
alarm persists, contact the service centre.
A09
Smoke sensor fault.
Smoke sensor fault. Cancel the alarm and turn the stove on again. If the
alarm persists, contact the service centre.
Service Routine maintenance warning (does not stop
operation).
When this blinking message appears at start-up,
it means that the operating hours preset before
maintenance have expired. Call the service centre.
ALARM RESET
To reset the alarm, press and hold key 1 (ESC) for a few seconds. The stove checks whether or not the cause of the alarm is ongoing.
In the rst case, the alarm continues to be displayed, in the second case it turns OFF.
If the alarm persists, contact a service centre.
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for MCZ MIDA AIR 8 XUP S1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of MCZ MIDA AIR 8 XUP S1 in the language / languages: English as an attachment in your email.

The manual is 3.02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of MCZ MIDA AIR 8 XUP S1

MCZ MIDA AIR 8 XUP S1 Installation Guide - English - 52 pages

MCZ MIDA AIR 8 XUP S1 User Manual - German - 32 pages

MCZ MIDA AIR 8 XUP S1 Installation Guide - German - 52 pages

MCZ MIDA AIR 8 XUP S1 User Manual - Dutch - 32 pages

MCZ MIDA AIR 8 XUP S1 Installation Guide - Dutch - 52 pages

MCZ MIDA AIR 8 XUP S1 User Manual - French - 32 pages

MCZ MIDA AIR 8 XUP S1 Installation Guide - French - 52 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info