694367

MCZ Duo Hydro Air Manual

65
Zoom out
Zoom in
Previous page
1/80
Next page
63
15 - SAFETY DEVICES AND ALARMS
Technical Dept. - All rights reserved - Reproduction is prohibited
WRITTEN ON THE
DISPLAY
TYPE OF PROBLEM SOLUTION
A08
FLUE GAS FAN
Faulty smoke fan.
Check that the lower compartment is clean (see
dedicated stove cleaning pages) and verify that it is
not obstructed, is clean and cancel the alarm.
If the alarm persists, contact the service centre.
A09
SMOKE TEMPERA
TURE PROBE
Smoke sensor fault.
Contact an authorised service centre to have the
component replaced and, if needed, replace the
component.
A11
GEAR REDUCER
Auger gear reducer fault.
The component is not working regularly.
Contact an authorised service centre to have the
component replaced and, if needed, replace the
component.
A13
BOARD TEMP
Electronic board overheating
Wait for the cooling phase to end, cancel the alarm
and reduce pellet loading (SETTINGS MENU - Pellet
recipe). If the alarm persists, contact the service
centre. .
A14
ACTIVE SENSOR
Active sensor anomaly
Active Plus sensor operation anomaly. Contact an
authorised service centre to have the component
replaced and, if needed, replace the component.
A18
WATER SIC
Water thermostat intervention
Water temperature is too high or thermostat
operational anomaly. If the alarm persists, contact the
service centre.
A19
WATER PROBE
Fault with water sensor
Possible fault in the safety component. Contact an
authorised service centre to have the component
replaced and, if needed, replace the component.
A20
AUX PROBE
Auxiliary probe fault
Possible component fault.
Check that the probe inserted in the system respects
the characteristics specied in the instructions (see
external probe).
Contact an authorised service centre to have the
component replaced and, if needed, replace the
component.
Exiting the alarm conditions
When the stove enters an alarm state, an automatic cooling/shut-o phase begins, at the end of which the cause of the alarm is displayed
on the small panel.
Before resetting the alarm, follow the controls indicated in the previous table, and then press the RESET key for a few seconds (or remove
power to the stove using the main ON/OFF switch on the back of the stove).
If the indicated actions do not resolve the problem, the alarm condition will occur once again with dierent timing based on the alarm
type: in this case, contact technical assistance.
Downloaded from www.Manualslib.com manuals search engine
… 65 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for MCZ Duo Hydro Air at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of MCZ Duo Hydro Air in the language / languages: English as an attachment in your email.

The manual is 9,85 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info