694363
40
Zoom out
Zoom in
Previous page
1/65
Next page
PELLET STOVES Chapter 4
INSTALLATION AND USE MANUAL
page 40
Operation Technical service - Rights reserved MCZ Group S.p.A. - Reproduction prohibited
12:07
31
°C
TU
23
°C
TIMER
ECO
12:06
31
°C
TU
23
°C
ECO
8:20
26
FR
20
°C
TIMER
°C
P1
5.5.3. TIMER mode (indicated by TIMER)
When you select this operating mode you can switch the product on
and off automatically according to 6 customisable time frames (P1 –
P6). In each time frame you can set:
The start-up time
The shut-down time
The desired room temperature in that time frame
The days of the week in which the time frame is active
When the stove is started up (manually using button A or automatically
using a time frame) the product operates in the automatic mode
described above. When a time frame is enabled it is automatically
displayed (P1 in figure 3) and the desired temperature modifies to the
value set in the time frame. The user can modify this value at any time,
in real time, as desired.
To learn how to set the time frames refer to paragraph 5.7.
5.5.4. ECO mode (indicated by ECO )
This mode enables/ disables when the remote control is switched on by
pressing button B for 5 seconds.
ECO mode is an automatic mode with the only difference that if the
temperature set is reached and maintained for the following 20 minutes
(regardless of the flame modulation) the product shuts down and
remains on stand-by until the room temperature drops 2 degrees below
the desired temperature (or until 5 minutes after the last shut down).
At this point the product restarts. Figure 4
If the room is not sufficiently insulated the flame modulation does not
allow the set temperature to remain satisfied for 20 consecutive
minutes and the product therefore does not shut down.
NOTE: We recommend that you use ECO mode only in well-
insulated rooms to prevent the appliance from starting up and
shutting down too frequently.
The remote control remains switched on, even while the product is
switched off due to ECO mode, to indicate that this shut down is only
temporary. Shutting down the product using button A exits ECO mode
and the product remains switched off.
In ECO mode you can also enable up to 6 automatic start-up/ shut
down time frames (E1 – E6). These are separate from those in the
TIMER mode (P1 – P6). If these time frames have been enabled the
message TIMER-ECO appears (figure 5) and is shown permanently
even when the remote control is switched off.
To learn how to set the time frames refer to paragraph 5.7.
NOTE: If the remote control shuts down by the TIMER, ECO
mode cannot restart until the user intervenes (button A) or the
next valid time frame is started. The use the TIMER combined
with ECO mode requires good knowledge of the operating logic
of the product.
FIG.5
FIG.4
FIG.3
Downloaded from www.Manualslib.com manuals search engine
40


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for MCZ Club Comfort Air 2011 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of MCZ Club Comfort Air 2011 in the language / languages: English as an attachment in your email.

The manual is 4,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info