812473
33
Zoom out
Zoom in
Previous page
1/36
Next page
33
18-FAULTS/CAUSES/SOLUTIONS
Technical Dept. - All rights reserved - Reproduction prohibited
ANOMALY POSSIBLE CAUSES SOLUTIONS
The boiler runs for a few minutes and
then goes out.
Start-up phase is not completed Repeat start-up
Temporary power cut Wait for the automatic restart
Clogged smoke duct Clean the smoke duct
Faulty or malfunctioning temperature probes Check and replace the probes
Faulty spark plug Check the spark plug and replace it, if
necessary
Pellets accumulate in the brazier, the
glass of the door gets dirty and the
ame is weak
Insucient combustion air Clean the brazier and check that all the
holes are clear. Perform a general cleaning
of the combustion chamber and the smoke
duct. Check that the entry of air is not
obstructed.
Damp or unsuitable pellets Change the type of pellets
Faulty smoke evacuation motor Check the motor and replace it, if necessary
The smoke evacuation motor does
not work
No electrical supply to the boiler. Check the mains voltage and the
protection fuse
The motor is faulty Check the motor and capacitor and replace
them, if necessary
Defective motherboard Replace the electronic board
Control panel broken Replace the control panel
In the automatic position the boiler
always runs at full power.
Thermostat is set to minimum Reset the temperature of the thermostat.
Room thermostat in position that always
detects cold.
Reposition of the probe
Malfunctioning temperature probe. Check the probe and replace it if necessary.
Faulty or malfunctioning control panel. Check the panel and replace if necessary.
The stove does not run No power supply Check that the plug is inserted and the
main switch is in the “I” position.
Pellet probe stop Cancel stoppage by changing the setting of
the rear thermostat. If the problem persists,
request assistance.
Blown fuse Replace the fuse.
Pressure switch broken (lockout indicated). Insucient pressure of water in boiler
Clogged smoke exhaust or smoke duct. Clean the smoke outlet and/or the smoke duct.
Water temperature sensor triggered Call for assistance
33


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for MCZ CLIO HYDRO 16 S2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of MCZ CLIO HYDRO 16 S2 in the language / languages: English as an attachment in your email.

The manual is 2.72 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of MCZ CLIO HYDRO 16 S2

MCZ CLIO HYDRO 16 S2 Installation Guide - English - 48 pages

MCZ CLIO HYDRO 16 S2 Installation Guide - German - 48 pages

MCZ CLIO HYDRO 16 S2 User Manual - German - 36 pages

MCZ CLIO HYDRO 16 S2 User Manual - Dutch - 36 pages

MCZ CLIO HYDRO 16 S2 Installation Guide - Dutch - 48 pages

MCZ CLIO HYDRO 16 S2 Installation Guide - French - 48 pages

MCZ CLIO HYDRO 16 S2 User Manual - French - 36 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info