684238
15
Zoom out
Zoom in
Previous page
1/621
Next page
STARTING AND STOPPING
English 15
Move the choke lever to Half Choke position as soon
as the engine sounds as if it is trying to start.
Pull starter cord while trigger is in the full throttle
position until engine starts.
Once engine is started leave the choke lever in Half
choke position for 20 seconds. Then move the choke
lever to RUN position.
If engine does not start move the choke lever to Full
Choke position and do the steps again.
Always pull starter cord straight out. Pulling the starter at
an angle will cause cord to rub against the eyelet. This
friction will cause the cord to fray and wear more quickly.
Always hold the starter handle when cord retracts. Never
allow cord to snap back from extended position. This
could cause cord to snag or fray and also damage the
starter assembly.
Warm engine
Set the choke control in the RUN position.
Then grasp the starter handle with your right hand and
pull the starter cord.
Stopping
Stop the engine by switching off the ignition.
CAUTION! The stop switch automatically returns to the
start position. In order to prevent unintentional starting,
the spark plug cap must be removed from the spark plug
when assembling, checking and/or performing
maintenance.
!
WARNING! When the engine is started
with full throttle the cutting attachment
will start to rotate immediately.
S1156009-38,T26CS_1.fm Page 15 Wednesday, April 6, 2016 1:15 PM
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for McCulloch T26CS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of McCulloch T26CS in the language / languages: All languages as an attachment in your email.

The manual is 36,33 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info