Message Cause Action
Poor signal quality
The connectivity circuit board in the
product is assembled upside down, or
the product itself is tilted or upside
down.
Verify the product is not upside down or
tilted. If not, the message requires ac-
tion by authorized service technician.
6.3 Information messages
Below a number of information messages are listed which may be shown in the display of the product.
Contact
McCulloch customer service if the same message appears often.
Message Cause Action
Low battery
The product cannot find the charging
station.
Check that the charging station and the
guide wire are installed in accordance
with the instructions. Refer to
To install
the guide wire on page 18
.
The guide wire is broken or not connec-
ted.
Find out where the break is and rectify
it.
The battery is spent. Replace the battery. Refer to
Battery
on page 32
.
The charging station’s antenna is de-
fective.
Check if the indicator lamp in the
charging station flashes red. Refer to
Indicator lamp in the charging station
on page 40
.
Settings restored
Confirmation that a
Reset all user set-
tings
has been carried out.
This is normal. No action required.
Guide not found
The guide wire is not connected to the
charging station.
Check that the guide wire connector is
tightly connected to the charging sta-
tion. Refer to
To install the guide wire
on page 18
.
Break in the guide wire. Find out where the break is. Replace
the damaged section of the guide wire
with a new loop wire and splice using
an original coupler.
The guide wire is not connected to the
boundary loop.
Check that the guide wire is connected
correctly to the boundary loop. Refer to
To install the guide wire on page 18
.
Guide calibration
failed
The product has failed to calibrate the
guide wire.
Check that the guide wire is installed
according to the instructions. Refer to
To examine where to put the guide wire
on page 17
. Also, check that the mini-
mum distance to the left of the guide
wire is met. Refer to
To examine where
to put the guide wire on page 17
.
Guide calibration
accomplished
The product has succeeded to calibrate
the guide wire.
No action required.
985 - 004 - 22.01.2019 Troubleshooting - 39
