684128
12
Zoom out
Zoom in
Previous page
1/320
Next page
MAINTENANCE
12 – English
Fit the washer and tighten the bolt correctly. The bolt
should be tightened with a torque of 45-60 Nm.
Pull the blade around by hand and make sure it
rotates freely. Test run the machine.
Spark plug
If the machine is low on power, difficult to start or runs
poorly at idle speed: always check the spark plug first
before taking other steps.
If the spark plug is dirty, clean it and check that the
electrode gap is 0,7-0,8 mm. Replace if necessary.
Adjusting the clutch wire
M46-140RX, M51-140RX, M51-170WRPX
Finely adjust the wire using the adjuster screw.
Roughly adjust the cluch wire when the fine
adjustment is not enough.
Extend the wire using the fine adjustment screw.
Roughly adjust the cluch wire by attaching it to the
different brackets on the clutch bar. Then adjust the
wire finely.
M46-140AWRX, M53-170AWRPX
Finely adjust the wire using the adjuster screw.
Air filter
Remove the air filter cover and take out the filter.
An air filter that has been in use for a long time cannot
be cleaned completely. The filter must therefore be
replaced with a new one at regular intervals.
A
damaged air filter must always be replaced.
When reassembling, make sure that the filter
completely seals against the filter holder.
Clean the paper filter
Clean the filter by knocking the filter against a flat
surface. Never use solvent with petroleum, for
example, kerosene, or compressed air to clean the
filter.
Cleaning the foam plastic filter
Remove the foam plastic filter. Wash the filter well in
tepid soapy water. After cleaning, rinse the filter well
in clean water. Squeeze out and allow the filter to dry.
NOTE! High pressure compressed air can damage
the foam. After cleaning the filter should be oiled using
engine oil. Wipe away excess oil by pressing a clean
cloth against the filter.
Oil change
Empty the fuel tank.
Unscrew the oil filler cap.
Place a suitable vessel to collect the oil in.
Drain the oil by tipping the engine so that the oil runs
out through the filler pipe. When the machine is tilted,
make sure the air filter always is placed in the highest
position. Ask where you can dispose of surplus
engine oil at your local petrol station.
Fill with new engine oil of a good quality. See
instructions in the section "Technical data".
Fuel system
Check that the fuel cap and its seal are not damaged.
Check the fuel hose. Replace if necessary.
NOTICE! Always use the recommended spark plug
type! Use of the wrong spark plug can damage the
piston/cylinder.
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for McCulloch M53-170AWRPX at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of McCulloch M53-170AWRPX in the language / languages: All languages as an attachment in your email.

The manual is 10,6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info