684123

McCulloch M46-150WR CLASSIC Manual

10
Zoom out
Zoom in
Previous page
1/348
Next page
M51-150WR CLASSIC, M53-150WR
CLASSIC)
1. Put the grass catcher frame into the fabric grass
bag. Make sure that the handle on the grass catcher
frame is on top of the grass bag.
2.
Attach the grass bag to the grass catcher frame with
the clips found on the fabric bag edge. (Fig. 23)
3. Lift the rear cover.
4. Attach the grass catcher to the top edge of the
chassis.
5. Put the lower part of the grass catcher into the grass
discharge channel.
To assemble the grass catcher
(M46-140R CLASSIC+, M46-145WRP
CLASSIC+)
1. Put the upper part of the grass catcher onto the
lower part of the grass catcher.
2. Attach the grass catcher frame with the clips. (Fig.
24)
3. Lift the rear cover.
4.
Attach the hooks on the grass catcher to the top
edge of the chassis. (Fig. 25)
5. Put the lower part of the grass catcher into the grass
discharge channel.
To assemble the mulch plug
A mulch kit is available as an optional accessory for
selected models only. Models M46-140R CLASSIC+,
M46-145WRP CLASSIC+, M51-150WR CLASSIC,
M53-150WR CLASSIC come with the mulch kit
supplied. Models M40-120 CLASSIC, M40-125
CLASSIC+ can not be used with a mulch kit.
1. Lift up the rear cover and remove the grass catcher.
2. Put the mulch plug into the discharge channel. (Fig.
26)
Operation
Introduction
WARNING: Before you operate the product,
you must read and understand the safety
chapter.
Before you operate the product
1. Read the operator's manual carefully and make sure
that you understand the instructions.
2. Examine the cutting equipment to make sure that it
is correctly attached and adjusted. See
To examine
the cutting equipment on page 12
.
3. Fill the fuel tank. See
To fill fuel on page 10
.
4. Fill the oil tank and do a check of the oil level. See
To do a check of the oil level on page 12
.
To fill fuel
If available, use low-emission/alkylate gasoline. If low-
emission/alkylate gasoline is not available, use good
quality unleaded gasoline or leaded gasoline. Use
gasoline with an octane number of 90 RON out of North
America (87 AKI in North America) or higher, and with a
maximum of 10% ethanol (E10).
CAUTION: Do not use gasoline with an
octane number less than 90 RON out of
North America (87 AKI in North America).
This can cause damage to the product.
1. Open the fuel tank cap slowly to release the
pressure.
2. Fill slowly with a fuel can. If you spill fuel, remove it
with a cloth and let remaining fuel dry off.
3.
Clean the area around the fuel tank cap.
4. Tighten the fuel tank cap fully. If the fuel tank cap is
not tightened, there is a risk of fire.
5.
Move the product a minimum of 3 m (10 ft) from the
position where you filled the tank, before a start.
To set the cutting height
1. Move the cutting height lever rearward to increase
the cutting height.
2. Move the cutting height lever forward to decrease
the cutting height. (Fig. 27)
CAUTION: Do not set the cutting height too
low. The blades can hit the ground if the
surface of the lawn is not level.
To start the product
1. Make sure that the ignition cable is connected to the
spark plug.
2.
The very first time you start the product, press the
primer bulb 5 times. The next time you start the
product when the engine is cold, press the primer
bulb 3 times. (Fig. 28)
3. Stay behind the product.
4. Hold the engine brake handle against the handlebar.
(Fig. 29)
5. Hold the starter rope handle with your right hand.
6. Slowly pull out the starter rope until you feel some
resistance.
7. Pull with force to start the engine.
10 869 - 004 - 03.12.2018
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for McCulloch M46-150WR CLASSIC at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of McCulloch M46-150WR CLASSIC in the language / languages: All languages as an attachment in your email.

The manual is 3,17 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info