684167
67
Zoom out
Zoom in
Previous page
1/108
Next page
67
6
WARTUNG DER BATTERIE
WARNUNG: Die Nichtbeachtung dieser Anweisungen
kann zu Funkenbildung, Lichtbogen oder offenen
Flammen führen, was zu schweren Körperverletzungen
oder Sachbeschädigungen führen kann. Legen
Sie den gesamten Schmuck wie Metallarmbänder,
Uhrenarmbänder, Ringe usw. ab, bevor Sie an der Batterie
(1) arbeiten. Wird die Batterie mit diesen Objekten berührt,
kann dies zu Verbrennungen führen.
WARNUNG: Stellen Sie sicher, dass sich der Zündschalter
des Traktors in der AUS-Position (OFF) befindet und der
Zündschlüssel ABGEZOGEN ist.
AUSBAU
Suchen Sie die silberne Masseschraube (2) an der rechten
Traktorplatte, über dem rechten Hinterrad.
Lösen Sie mit einem ½ Zoll (13mm) Schraubenschlüssel
die silberne Masseschraube (2) vollständig, und legen
Sie diese für später beiseite.
Ziehen Sie die Schutzmanschette (3) so über das frei
liegende Polende (4), dass dieses VOLLSTÄNDIG mit
der Schutzmanschette verdeckt ist.
Lösen Sie mit einem 7/16 Zoll (11mm) Schraubenschlüssel
das größere ROTE (+) Batteriekabel (5) vom Stehbolzen
des Anlassmagnetschalters (6). ENTFERNEN SIE
KEINESFALLS das kleinere rote Kabel vom Kabelbaum
am Stehbolzen des Anlassmagnetschalters.
VORSICHT: Die Batterieabdeckungshalterung (7) muss in
geöffnetem Zustand auf der Batterieabdeckung (8) aufliegen
und in geschlossenem Zustand in die Halter (9) oberhalb der
Batterieabdeckung (8) einrasten.
Öffnen Sie hinten am Traktor die Batterieabdeckung (8)
und sichern Sie diese im Schlitz.
Ziehen Sie die Batterie (1) mit beiden angeklemmten
Kabeln aus dem Batteriefach und legen Sie diese auf
die Batterieabdeckung (8).
WARTUNG
Lösen Sie die Vierkantmuttern (10), die Schrauben (11)
und klemmen Sie die Batteriekabel ab.
Reinigung / Ausbau / Austausch der Batterie (1) nach
Bedarf.
EINBAU
WARNUNG: Der Pluspol (+) muss ZUERST angeschlossen
werden, um Funken durch unbeabsichtigte Erdung zu
vermeiden.
Schließen Sie zuerst das ROTE Batteriekabel (5) an
Plus (+) an, und danach das SCHWARZE Kabel (12) an
Minus (-) an; benutzen Sie dazu die zuvor ausgebauten
Vierkantmuttern (10) und die Schrauben (11). Die
Schrauben fest anziehen.
HINWEIS: Das SCHWARZE Kabel (12) muss mit einer
Schutzmanschette (3) versehen sein, unter der das Polende
mit dem Traktorrahmen verbunden ist.
Fetten Sie die Batteriepole (13) zum Schutz vor Korrosion
ein.
• Der Einbau erfolgt in umgekehrter Reihenfolge des
Ausbaus.
BATTERY MAINTENANCE
WARNING: Not following instructions can result in
sparks, arcing or open flames which could lead to serious
personal injury or property damage. Before handling
battery (1), re move metal brace lets, wrist watch bands,
rings, etc. from your person. Touch ing these items to
battery could result in burns.
WARNING: Ensure tractor ignition switch is in the OFF
position and ignition key is REMOVED.
REMOVAL
Locate silver ground screw (2) on right side plate or tractor,
above right rear tire.
Using a ½ inch (13mm) wrench or socket, completely
remove the silver ground screw (2) and set aside.
Pull protective sleeve (3) over exposed terminal end (4)
COMPLETELY covering terminal end.
Using a 7/16 inch (11mm) wrench or socket, remove
larger RED (+) battery cable (5) from solenoid stud (6).
DO NOT REMOVE smaller red wire from wiring harness
on solenoid stud.
CAUTION: Battery door stand (7) must be secured in slot
below battery door (8) when in the open position and secured
in battery door holders (9) above battery door (8) when in
the closed position.
From the rear of the tractor, open battery door (8) and
secure in slot.
Pull battery (1) with both cables attached out of battery
compartment and rest on battery door (8).
MAINTENANCE
Remove square nuts (10), bolts (11) and battery cables.
Clean / remove / replace battery (1) as needed.
INSTALLATION
WARNING: Positive terminal (+) must be con nect ed FIRST
to prevent sparks from accidental ground ing.
Connect the RED battery cable (5) to (+) and then the
BLACK cable (12) to (-) using square nuts (10) and bolts
(11) previously removed. Tighten securely.
NOTE: BLACK cable (12) should have protective sleeve (3)
by the terminal end connected to tractor frame.
Grease battery terminals (13) to prevent cor ro sion.
Installation is reverse of removal.
67


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for McCulloch M125-97TC Powerdrive at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of McCulloch M125-97TC Powerdrive in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 4,28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info