684146

McCulloch M115-77TC Manual

52
Zoom out
Zoom in
Previous page
1/92
Next page
52
Cutting tips
• Clear the lawn from stones and other objects which can
be thrown away by the blades.
• Localize and mark stones and other fixed objects to avoid
collision.
• Begin with a high cutting height and reduce until the
required cutting result is obtained.
• The cutting result is best with high engine speed (blades
rotate quickly) and low gear (ma chine goes slowly). If the
grass is not too long and thick the drive speed can be
increased by selecting a higher gear or increasing the
motor speed, without affecting the cutting result.
• The best lawn is achieved if the grass is cut often. Cutting
becomes more even and the cut grass is more evenly
dis trib ut ed over the surface. Total time taken is not greater,
since higher drive speed can be se lect ed with out af fect ing
the cut ting results.
• Avoid cutting wet grass. The cutting results will be worse
since the wheels will sink into the soft lawn.
• Spray the cutting unit with water underneath after use.
Ratschläge zum Rasenmähen
• Steine und andere Gegenstände vom Rasen entfernen,
da diese sonst von den Mähklingen weggeschleudert
werden.
• Große Steine und andere Gegenstände im Mähbereich
kennzeichnen, um ein Auffahren zu vermeiden.
• Mit hoher Mähhöhe beginnen und diese dann senken,
bis das gewünschte Ergebnis erzielt wird.
• Das Mähergebnis ist am besten mit hoher Motordrehzahl
(die Klingen rotieren schnell) und niedrigem Gang (die
Maschine fährt langsam).Wenn das Gras nicht zu lang
und zu dick ist, kann die Antriebsgeschwindigkeit durch
Auswahl einer höheren Übersetzung oder Erhöhung der
Motordrehzahl erhöht werden, ohne dass dadurch das
Mähergebnis beeinträchtigt wird.
• Der Rasen wird am schönsten, wenn er oft gemäht wird.
Das Gras wird dadurch gleichmäßiger gemäht und das
gemähte Gras wird gleich mä ßi ger über die Oberfläche
verteilt. Der gesamte Zeitaufwand ist nicht größer, da
eine höhere Fahrgeschwindigkeit gewählt werden kann,
ohne daß schlechter gemäht wird.
• Wenn möglich, keinen nassen Rasen mähen. Das Mäher-
gebnis wird schlechter, da die Räder im weichen Rasen
einsinken.
• Nach jedem Einsatz ist das Mähaggregat von unten mit
Wasser abzuspülen.
Sistema per operazioni in retromarcia (ROS)
Il Vostro trattore possiede un Sistema per operazioni in re-
tromarcia (ROS). Qualsiasi tentativo da parte dell’operatore
di guidare nella direzione opposta con la frizione abbassata
comporterà lo spegnimento del motore se la chiave di accen-
sione non è inserita nel ROS nella posizione "ON".
ATTENZIONE! Fare retromarcia con la frizione abbassata
durante la guida è sconsigliato. Girare il ROS alla posizione
"ON", per permettere l’operazione di retromarcia con la frizio-
ne abbassata, dovrà essere effettuato soltanto al momento
in cui l’operatore decide che sia necessario riposizionare la
macchina con l’innesto inserito. Non falciare in retromarcia
se non è assolutamente necessario.
L’UTILIZZO DEL ROS
• Spingere il pedale frizione/freno fino in fondo e mantenere.
• Con il motore accesso, girare la chiave di accensione in
direzione antiorario con il ROS in posizione "ON".
• Guardare giù e indietro prima di fare retromarcia.
• Spostare la leva del cambio in posizione di retromarcia
(R) e rilasciare lentamente il pedale frizione/freno per
iniziare il movimento.
• Quando l’utilizzo nel ROS non serve più, girare la chiave
di accensione in direzione orario con il motore in posizione
"ON".
Systeem voor achteruit (ROS)
Uw tractor is uitgerust met een systeem voor achteruit (ROS).
Elke poging door de bestuurder om achteruit te rijden waarbij
het aankoppelingspedaal actief is, zal de motor doen afslaan,
tenzij het contactsleuteltje zich in de "ON"-positie van de
ROS bevindt.
WAARSCHUWING! Achteruit rijden met het aankoppeling-
spedaal actief tijdens het maaien wordt sterk afgeraden. Als
men de ROS "ON:" zet, om achteruit rijden met het aankop-
pelingspedaal actief mogelijk te maken, dient dit alleen te
gebeuren als de bestuurder beslist dat het nodig is de machine
een andere positie te geven met wat aangekoppeld is. Maai
niet achteruit, tenzij dit absoluut nodig is.
WERKEN MET DE ROS
• Druk de koppeling/het rempedaal totaal in en houd dit vast.
• De motor loopt en draai de contactschakelaar tegen de
klok in naar de positie "ON" van de ROS.
• Kijk naar beneden en achter u voor u achteruit rijdt.
• Verplaats de versnellingshendel naar de positie achteruit
(reverse – R) en laat langzaam het koppelingspedaal/het
rempedaal los om met bewegen te beginnen.
• Wanneer men de ROS niet langer nodig heeft, draait u
het contactsleuteltje met de klok mee in positie "ON" van
de motor.
5
… 52 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for McCulloch M115-77TC at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of McCulloch M115-77TC in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 4,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info