684164

McCulloch M110-97T Classic Manual

70
Zoom out
Zoom in
Previous page
1/88
Next page
70
Assemble in the reverse order to dismantling. Check that
the belt lies inside all the belt guides. Use original belts only
when replacing!
Der Einbau erfolgt in umgekehrter Reihenfolge. Prüfen,
daß der Riemen innerhalb aller Riemenführer liegt. Beim
Auswechseln nur Originalriemen verwenden!
La mise en place d'une courroie se fait dans l'ordre inverse
de la dépose. Vérifier que la courroie est bien positionnée
devant tous les guides de courroie. Utiliser exclusivement
une courroie d'origine lors d'un remplacement!
El montaje se hace en el orden inverso al desmontaje. Con-
trolar que la correa se halla por dentro de todas las guías.
Montar únicamente correas originales!
Il montaggio avviene in ordine inverso. Controillare che
la cinghia sia dietro ai guida-cinghia. Usare solo cinghie
originali!
De montering vindt in omgekeerde volgorde plaats als de de-
montering. Controleer of de snaar binnen alle riem-geleiders
ligt. Gebruik uitsluitend originele riemen bij vervanging!
Replacement of drive belt
Dismantle the cutting unit as described previously
Engage the parking brake and work off the belt upwards
from the pulley (1), the clutch pulley (2) and the engine's
drive wheel (3). Work off the belt upwards from the pulley at
the rear axle (4).
Auswechsein des Treibriemens
Mähaggregat ausbauen.
Feststellbremse ansetzen und den Riemen vom Laufrad (1),
dem Kupplungsriemenrad (2) und dem Motorantriebsrad (3)
abbauen. Riemen von der Riemenscheibe an der Hinterachse
abheben (4).
Remplacement de la courroie d'entraînement
Désaccoupler le carter de coupe et le sortir de sous le tracteur
comme indiqué précédemment.
Serrer le frein de stationnement et retirer la courroie
d'entraînement de la poulie (1), puis de la poulie de ten-
sion (2) et de la poulie motrice (3). Enfin, sortir la courroie,
par l'arrière, à partir de la poulie (4) située sur le carter de
trans mis sion.
Cambio de correa propulsora
Desmontar el equipo de corte del tractor.
Aplicar el freno de estacionamiento y tirar hacia arriba de la
correa para sacarla de la rueda libre (1), de la acoplamiento
(2) y de la propulsora del motor (3). Quitar la correa hacia
arriba (4).
Sostituzione della cinghia di trazione
Smontare il tagliaerba.
Inserire il freno di parcheggio e staccare la cinghia dalla puleg-
gia (1), da quella della frizione (2) e da quella del motore (3).
Sfilare la cinghia verso l’alto, all’asse posteriore (4).
Vervangen van de aandrijfriem
Verwijder de maaikast van de tractor.
Trek de handrem aan en trek de riem omhoog van het loopwiel
(1), de koppelingswielschijf (2) en het aandrijfwiel van de motor
(3). Trek de riem van de poelie bij achtera naar boven (4).
02952
2
1
4
3
6
… 70 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for McCulloch M110-97T Classic at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of McCulloch M110-97T Classic in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 2,8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info