684163
42
Zoom out
Zoom in
Previous page
1/100
Next page
42
5. Commande d'embrayage et de débrayage du
carter de coupe
Pousser le levier vers l'avant et le verrouiller pour embrayer
le carter de coupe. Les courroies d'entraînement seront alors
en tension et les lames commenceront à tourner. Ramener le
levier vers l'arrière pour débrayer le carter de coupe, les lames
seront alors freinées par le frottement des patins de frein sur
les poulies d'entraînement. Si le bac n’est pas complètement
fermé, les lames ne seront pas actionnées lors du mouvement
du levier vers l’avant et le moteur s’arrêtera. Si le bac se
détache pendant la coupe, le moteur s’arrêtera.
5. Acoplamiento y desacoplamiento del equipo de
corte
Lleve la palanca hacia adelante para acoplar la propulsión del
equipo de corte. Se tensarán entonces las correas propulsoras
y empezarán a girar las cuchillas. Si la palanca se lleva hacia
atrás se desacopla la propulsión al mismo tiempo que la
rotación de las cuchillas es frenada por las zapatas de freno
que aprietan las ruedas de las correas. Si la ensacadora no
está completamente cerrada, las cuchillas no se accionan al
mover el brazo hacia delante y el motor se para. El motor se
para cuando la ensacadora se suelta durante la operación
de corte.
5. Inserimento/disinserimento del dispositivo di
taglio
Premere in avanti la leva per avviare il tagliaerba. La cinghia
entra in tensione e le lame cominciano a girare. Tirando indietro
la leva il tagliaerba viene disinserito e le lame vengono frenate
dalle ganasce dei freni che agiscono contro la puleggia. Se
il sacco non è completamente chiuso, le lame non saranno
completamente inserite quando la leva viene spostata in avanti
e il motore si spegnerà. Se il sacco si disinserisce durante
l’operazione di taglio, il motore si spegnerà.
5. Koppelen en onkoppeleen van de maaikast
Breng de hendel naar voren om de aandrijving van de
maaikast te koppelen. Daarbij wordt de aandrijfriem gesteld
en de messen beginnen te roteren. Wordt de hendel naar
achteren gebracht, wordt tegelijkertijd de rotatie van de messen
afgeremd, doordat de remblokken tegen de poelie lopen. Als
de opvangbak niet volledig is gesloten, zullen de messen niet
worden ingeschakeld als de hendel naar voren wordt bewogen
en slaat de motor af. Als de opvangbak tijdens het snijden
losraakt, zal de motor uitschakelen.
5. Connection/disconnection of the cutting unit
Move the lever forward to connect the drive to the cutting
unit, whereby the drive belt is tensioned and the blades begin
to rotate. If the lever is moved backwards the drive will be
disconnected and the rotation of the blades slowed down by
the action of the brake shoes on the pulley. If the bagger is not
fully closed, blades will not be engaged when lever is moved
forward and the engine will shut off. If the bagger becomes
disengaged during cutting, the engine will shut off.
5. Ein und Ausschalten des Mähaggregats
Den Hebel nach vorn führen, um den Antrieb des Mähers
ein-zukuppeln. Dabei wird der Antriebsriemen gespannt
und die Riemen beginnen sich zu drehen. Wenn der Hebel
zurückge-zogen wird, wird der Antrieb ausgekuppelt und die
Drehung der Klingen wird durch an die Riemenrollen angesetzte
Bremsklöt-ze gebremst. Wenn der Sack nicht vollständig
geschlossen ist, verzahnen die Klingen nicht, wenn der Hebel
nach vorn geschoben, und der Motor wird abgeschaltet.
Wenn der Grasfängersack beim Mähen ausklinkt, schaltet
sich der Motor ab.
3
5
42


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for McCulloch M110-77TC Classic at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of McCulloch M110-77TC Classic in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 4,65 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info