GB
Adjusting the harness belt (fig. B)
The harness belt (belt system) must be adjusted to suit your childs body. The harness shoulder belts must be
threaded through the slots nearest to the shoulders of the child.
Adjust the harness shoulder belts as follows (fig. B)
• Open the door of the storage compartment at the back of the shell.
• Pull the shoulder belts through the slots in the cover and the shell.
• Thread the shoulder belts through the correct slots in the shell and cover.
Alter the adjuster belt (belt system) as follows (fig. C)
To loosen: • Press the adjuster button at the front of the shell.
• Pull both harness shoulder belts simultaneously towards you.
To tighten: • Pull the adjuster belt at the front of the shell tight until the harness belt lies firmly against the child.
• The central adjuster belt can be fastened underneath the shell (fig. D).
Optional: Support pillow (fig. E-F)
The Maxi-Cosi Citi Side Protection System is supplied with a removable support pillow (fig. E). This helps the lying
position of the baby and supports the head sideways. The support pillow can be used for a longer period of time if
the foam wedge is removed (fig. F). To remove the foam wedge, open the gauze side flaps. When replacing the
foam wedge ensure that it is completely covered by the gauze side flaps. We recommend that you do not use the
support pillow for longer than 5 months.
Using the Maxi-Cosi Citi Side Protection System in the car (fig. G-H)
Please pay attention to the following when installing the Maxi-Cosi Citi Side Protection System in the car.
• Do not use a child safety seat if the vehicle is equipped with a front airbag, as this can be fatal. This does not
apply to so-called side airbags.
• Note the difference between the lap belt (fig. G1) and the shoulder belt (fig. G2) when installing the seat in the
car.
• Always place the seat in a rearward facing position (with the child’s back in the direction of traffic) with the
carrying handle in the upright position (fig. H1).
Instructions for use
11
