506269

MaxGear MAX 5073 super bass system Manual

7
Zoom out
Zoom in
Previous page
1/28
Next page
MAX 5073
Super Bass System
TROUBLE SHOOTING
Before removing your Amplifier, refer to list below and follow suggested procedure. Speakers and
their wires should be tested first.
No Output:
a. Confirm that all terminal strip connections are firmly connected.
b. Check in-line and built-in fuses. Both “+12V” and “RMT” terminals must have +12Volts to chassis
ground.
c. Confirm that signal source (Car Radio/Deck, EQ, X-over etc.) is connected and is supplying output
signal.
To confirm that the Amplifier is working, connect an RCA patch cord to LEFT & RIGHT low-Level inputs
of Amplifier only (Do not connect the other end of the patch cord).
Briefly tap the center pin of each (disconnected) RCA plug on the other (disconnected) end with y
our
finger
. This should produce a noise (feedback) in the speakers.
Only One Channel Works:
a. Confirm that speaker terminal strip connections are firmly connected.
b. Check “BALANCE” control on Car Stereo (or signal source) to verify is at mid-point.
c. If using RCA Low-Level inputs, reverse the input plugs at the Amplifier (right to left or vice versa).
If the channel that is silent reverses position, the problem is in the Car Stereo(EQ, X-over, or other
signal source) or connecting cable.
Weak Output
a. If noise is a “whine” that goes and down with engine speed, confirm that Amplifier and any other
source unit (Radio, EQ, X-over etc.) is properly grounded.
b. A “clicking” or “popping” noise at a rate that follows engine speed is generally induced by the vehi-
cles ignition system.
Confirm that the v
ehicle is equipped with resistor plugs and plug wires. Or, ignition system may need
service.
c. Speaker and input wires should not be routed next to wires that interconnect lights and other
accessories/equipment.
d. If above steps do not improve/clear noise interference, the system should be checked by a profes-
sional mobile audio installer.
… 7 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for MaxGear MAX 5073 super bass system at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of MaxGear MAX 5073 super bass system in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1,45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info