16 17MAXDATA PLATINUM 520 ServerServer Board Installations and upgrades
16 17MAXDATA PLATINUM 520 ServerServer Board Installations and upgrades
6. Make sure the clips at either end of the DIMM socket(s) are pushed outward to the open
position.
7. Holding the DIMM by the edges, remove it from its anti-static package.
8. Position the DIMM above the socket. Align the small notch in the bottom edge of the DIMM
with the keys in the socket (see inset in Figure 5.)
9. Insert the bottom edge of the DIMM into the socket.
10. When the DIMM is inserted, push down on the top edge of the DIMM until the retaining clips
snap into place. Make sure the clips are firmly in place.
11. Reconnect or replace any internal components you needed to disconnect or remove.
12. Replace the server’s cover. Reconnect any external components you needed to disconnect.
13. Attach the AC power cord.
Removing DIMMs
To remove a DIMM, follow these steps:
1. Observe the safety and ESD precautions at the end of this manual. See“Installation
Precautions”.
2. Turn off all peripheral devices connected to the server. Turn off the server.
3 . Remove the AC power cord from the server.
4. Remove the server’s cover. See your chassis documentation for instructions.
5. Gently spread the retaining clips at each end of the socket. The DIMM pops out of the socket.
6. Hold the DIMM by the edges, lift it away from the socket, and store it in an anti-static package.
7. Reconnect or replace any internal components you needed to disconnect or remove.
8. Replace the server’s cover. Reconnect any external components you needed to disconnect.
9. Attach the AC power cord.
