171515
9
Zoom out
Zoom in
Previous page
1/35
Next page
PB 9MAXDATA Server PLATINUM 500 I M7Server System Features
2 Server System Features
This chapter briefly describes the main features of the server system. This chapter provides a list of
server system features and diagrams showing the location of important components and connections
of the server system.
Table 2 summarizes the features of the server system.
Table 2. Server System Features
Merkmal Beschreibung
Server board
Intel
®
S5500BC
Processors
Up to two Intel
®
Xeon
®
5500 processors with a thermal design power (TDP) of up
to 95 W
System memory
8 DIMM slots, 4 per processor, distributed over two memory channels
Up to 32 GB system memory
800/1066/1333 MT/s ECC registered (RDIMM) or unbuffered (UDIMM) DDR3
memory
No mixing of RDIMMs and UDIMMs
Chipset
Intel
®
5500 Chipset IOH
Intel
®
82801Jx I/O Controller Hub (ICH10R)
Peripheral
interfaces
External connections:
One DB-15 graphics port
One serial DB-9 port
Two RJ45 network ports for 10/100/1000 Mbps
Four USB 2.0 ports (back panel)
Two USB 2.0 ports (front)
Internal connections:
One USB connector for two USB 2.0 ports
One DH10 connector for serial A port
Six SATA-II ports with integrated RAID 0/1/10 support
One port for an optional remote management module 3
Graphics
On-board controller ServerEngines LLC Pilot II with integrated 2D video controller,
64 MB DDR2 memory, 8 MB of which is graphics memory
LAN
Two RJ45 ports for 10/100/1000 Mbps Ethernet LAN:
One Intel
®
82574L GbE controller
One Intel
®
82567 GbE controller
Expansion
capabilities
Two PCI-E 2.0 x8 expansion slots
One PCI-E 2.0 x8 expansion slot with x4 connection
One PCI-E 1.1 x4 expansion slot
One 5 V 32-bit / 33 MHz PCI expansion slot
HDD Cages Up to 2 HDD cages with max. ten 2.5” or eight 3.5” HDD
a)
Drive cage for fixed 3.5” hard drives (max. 1 per system, 2 HDD supported)
b) SAS / SATA cage with four 3.5” hot-swap drive bays
c) SAS / SATA cage with six 2.5” hot-swap drive bays, expander backplane with
two 7-pin SATA connectors
HDD cages can be combined
SAS support through optional SAS controller
Power supply Simple or redundant 600 W / 650 W power supply
Fan Three 120 mm chassis fan
One non-redundant fan in every power supply
Server
management
An integrated IPMI 2.0-compliant baseboard management controller
Support for remote management module 3 (“KVM over IP”)
Support for system management software
Light Guided Diagnostics on replaceable units (FRUs)
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Maxdata platinum 500 i at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Maxdata platinum 500 i in the language / languages: English as an attachment in your email.

The manual is 1,41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info