After placing the treadmill in the position it will be used, the belt must be checked for
proper tension and centering. The belt might need to be adjusted after the first two hours
of use. Temperature, humidity, and use cause the belt to stretch at different rates. If the
belt starts to slip when a user is on it, be sure to follow the directions below.
1) Locate the two hex head bolts on the rear of the treadmill. The bolts are located at each
end of the frame at the back of the treadmill. These bolts adjust the rear belt roller. Do
not adjust until the treadmill is on. This will prevent over tightening of one side.
2) The belt should have equal distance on either side between the frame. If the belt is touching
one side, do not start the treadmill. Turn the bolts counter clockwise approximately one
full turn on each side. Manually center the belt by pushing the belt from side to side
until it is parallel with the side rails. Tighten the bolts the same amount as when the
user loosened them, approximately one full turn. Inspect the belt for damage.
3) Start the treadmill running belt by pressing the GO button. Increase speed to 3 mph
(~4.8 kph) and observe the belt position. If it is moving to the right, tighten the right
bolt by turning it clockwise ¼ turn, and loosen the left bolt ¼ turn. If it is moving
to the left, tighten the left bolt by turning it clockwise ¼ turn and loosen the right
¼ turn. Repeat Step 3 until the belt remains centered for several minutes.
4) Check the tension of the belt. The belt should be very snug. When a person
walks or runs on the belt, it should not hesitate or slip. If this occurs, tighten
the belt by turning both bolts clockwise ¼ turn. Repeat if necessary.
NOTE: Use the orange strip in the lateral position of the side rails as criteria to confirm the belt is properly
centered. It is necessary to adjust the belt until the edge of the belt is parallel to the orange or white strip.
WARNING!
Do not run belt faster than 3 mph (~4.8 kph) while centering. Keep fingers, hair and clothing away from belt at all times.
Treadmills equipped with side handrails and front handlebar for user support and emergency dismount, press emergency button to stop the machine for emergency dismount.
TIGHTENS RIGHT SIDE OF ROLLERTIGHTENS LEFT SIDE OF ROLLER
BELT IS TOO FAR TO THE LEFT SIDEBELT IS TOO FAR TO THE RIGHT SIDE
ENGLISH
PRODUCT SPECIFICATIONS
PERFORMANCEPERFORMANCE PLUS
CONSOLETOUCH XLTOUCHPREMIUM LED
LED / GROUP
TRAINING LED
TOUCH XLTOUCHPREMIUM LED
LED / GROUP
TRAINING LED
Max User Weight
182 kg /
400 lbs
227 kg /
500 lbs
Product Weight
199.9 kg /
440.7 lbs
197 kg /
434.3 lbs
195.2 kg /
430.4 lbs
194.5 kg /
428.8 lbs
220.5 kg /
486.1 lbs
217.6 kg /
479.7 lbs
215.8 kg /
475.8 lbs
215.1 kg /
474.2 lbs
Shipping Weight
235.6 kg /
519.4 lbs
231 kg /
509.3 lbs
229.2 kg /
505.3 lbs
228.5 kg /
503.8 lbs
249 kg /
549 lbs
244.4 kg /
538.8 lbs
242.6 kg /
534.8 lbs
241.9 kg /
533.3 lbs
Overall Dimensions
(L x W x H)*
220.2 x 92.6 x 175.1 cm /
86.7” x 36.5” x 68.9”
220.2 x 92.6 x 168.5 cm /
86.7” x 36.5” x 66.3”
227 x 92.6 x 175.5 cm /
89.4” x 36.5” x 69.1”
227 x 92.6 x 168.9 cm /
89.4” x 36.5” x 66.5”
* Ensure a minimum clearance width of 0.6 meters (24”) for access to and passage around MATRIX equipment.
Please note, 0.91 meters (36”) is the ADA recommended clearance width for individuals in wheelchairs.
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for Matrix Performance Treadmill at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of Matrix Performance Treadmill in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Spanish as an attachment in your email.
The manual is 21,83 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.
