785585
4
Zoom out
Zoom in
Previous page
1/20
Next page
SAFETY GUIDELINES AND MEASURES
4 Copyright © 2013 Mastervolt / January 2013 / GMDSS Mass Charger Alarm Interface Copyright / EN
2 SAFETY GUIDELINES AND MEASURES
2.1 WARNINGS AND SYMBOLS
Safety instructions and warnings are marked in this
manual by the following pictograms:
A procedure, circumstance, etc which
deserves extra attention.
CAUTION!
Special data, restrictions and rules with regard
to preventing damage.
WARNING
A WARNING refers to possible injury to the
user or significant material damage to the
charger if the user does not (carefully) follow
the procedures.
2.2 USE FOR INTENDED PURPOSE
1 The GMDSS Interface is constructed as per the
applicable safety-technical guidelines.
2 Use the GMDSS Interface only:
In combination with a Mastervolt Mass series
battery charger
in an approved application
in a technical correct condition;
in a closed, well-ventilated room, protected
against rain, moisture, dust and non condensing
circumstances;
observing the instructions in the user’s manual
WARNING
Never use the GMDSS Interface in situations
where there is danger of gas or dust explosion
or potentially flammable products!
3 Use of the GMDSS Interface other than mentioned in
point 2 is not considered to be consistent with the
intended purpose. Mastervolt is not liable for any
damage resulting from the above.
2.3 ORGANIZATIONAL MEASURES
The user must always:
have access to the user's manual;
be familiar with the contents of this manual. This
applies in particular to chapter 2, Safety
Guidelines and Measures.
2.4 MAINTENANCE & REPAIR
1 If the GMDSS Interface and/or the Mass Battery
Charger is switched off during maintenance and/or
repair activities, it should be secured against
unexpected and unintentional switching on:
Remove and tag out the fuse(s) from the AC
supply or;
Switch off and tag out the AC circuit breaker;
Switch off and tag out the connection with the
batteries and remove the fuses;
Take adequate precautions to ensure that third
parties cannot reverse the measures taken.
2 If maintenance and repairs are required, use only
original spare parts.
2.5 GENERAL SAFETY AND INSTALLATION
PRECAUTIONS
Do not expose the GMDSS Interface to rain, snow,
spray, moisture, excessive pollution and condensing
circumstances.
Short circuiting or reversing polarity will lead to serious
damage to batteries, GMDSS Interface and the wiring.
Fuses between the batteries and the Interface can not
prevent damage caused by reversed polarity and the
warranty will be void.
Protect the DC wiring with fuses, according to the
guidelines in this manual.
Connection and protection must be done in
accordance with local standards.
Do not work on the Interface or system if it is still
connected to a power source. Only allow changes in
your electrical system to be carried out by qualified
electricians.
Check the wiring and connections at least once a year.
Defects such as loose connections, burned cables etc.
must be corrected immediately.
Do not touch the equipment when wet or if your hands
are clammy.
To open the cabinet of the Mass Battery Charger,
follow the instructions as stated in the user’s manual of
the battery charger.
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Mastervolt GMDSS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Mastervolt GMDSS in the language / languages: English as an attachment in your email.

The manual is 0.68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info