614265

Mastercraft X46 Manual

130
Zoom out
Zoom in
Previous page
1/285
Next page
secured tightly in place prior to launching
the boat into the water. Failure to do so will
allow water to intrude into the bilge system
and may result in serious injury or death as
a result of the boat sinking.
Center drain piehole lids should be
secured prior to boat operation. It can be
possible to misdirect the cross-threads
when re-installing. Retry until the lid
is secure, level with the deck. Not only
can additional water from the deck in-
trude if the lid is not secured, but in-
dividuals on-board may injure them-
selves if they misstep in the area of the
center drain.
The sea strainer should be checked be-
fore each outing. See the Care and Main-
tenance section of this Owner’s Manual
for details on how to properly inspect it.
As equipped, the strainer operates auto-
matically and does not require a switch or
gauge to monitor. Regular maintenance,
however, is important.
Special Note:
Because the bilge pump operates
even when the boat is shut OFF to pre-
vent excessive water on-board, if the
pump runs fairly frequently, it can cause
the battery(ies) to fully discharge. This is
a signal that the boat is either taking on
too much water from a leak or that the
boat is being left in the water for periods
that are too long. Anytime the battery is
low or discharged, properly recharge it
prior to operation.
Bilge pumps will not operate in either the
manual or automatic mode if the batteries
are fully discharged. This condition may al-
low excessive water in the hull, which can
damage or sink the boat. Make frequent
checks of the battery charge and bilge
pump function when the boats are moored
and exposed to the elements.
Troubleshooting:
The bilge system is among the most
important systems in the boat. Attention
should always be paid to proper operation.
1) If the boat does not automatically pump
water out of the system when the igni-
tion key is ON, verify that the bilge
switch is turned to automatic.
Boat Operations • 2014 MasterCraft Owners Manual Page 4-21
B O A T O P E R A T I O N S
… 130 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Mastercraft X46 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Mastercraft X46 in the language / languages: English as an attachment in your email.

The manual is 5,67 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info