• Contains small parts which may be a choking hazard.
Not suitable for children under age three.
• Set a low volume setting before using the headphones.
• Long-term exposure to loud music or sounds may cause hearing damage. It is best to avoid high volume levels when using these
headphones, especially for extended periods.
• Do not use these headphones when operating a motor vehicle, a bicycle, machinery or where your inability to hear outside sounds may
present a danger to you or others.
• Do not drop, sit on, or allow the headphone to be immersed in water.
• Keep away from fire, water, and high voltage equipment.
• Do not modify, disassemble, open, drop, crush, puncture, shred the headphone or heat above 140°F (60°C).
• Do not short-circuit the included battery or its cells.
• In the event of a battery cell leaking, do not allow the liquid to come in contact with the skin or eyes.
CAUTIONS
• Using these headphones limits your ability to hear noises around you, regardless of listening volume. Please use caution when using these headphones.
• The pads that accompany these headphones may deteriorate over time. Please make sure to use suitable pads on the headphones at all times.
• FCC ID: 2AAGF-MONITOR and IC ID: 11153A-MONITOR, are located under the right ear cushion. To remove, hold the ear cap and remove the
magnetic ear cushion.
FCC WARNING
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. Note: This
equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
IC WARNING
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device
may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the
device. The device is compliance with RF field strength limits, users can obtain Canadian information on RF exposure and compliance. This Class B
digital apparatus complies with Canadian ICES-003. CAN ICES-3(B)/NMB-3(B).
ADMINISTRATIVE REGULATIONS ON LOW POWER RADIO WAVES RADIATED DEVICES WARNING:
ARTICLE 12 Without permission granted by the NCC, any company, enterprise, or user is not allowed to change frequency, enhance transmitting
power or alter original characteristic as well as performance to an approved low power radio-frequency devices. ARTICLE 14 The low power
radio-frequency devices shall not influence aircraft security and interfere legal communications; If found, the user shall cease operating
immediately until no interference is achieved. The said legal communications means radio communications is operated in compliance with the
Telecommunications Act. The low power radio-frequency devices must be susceptible with the interference from legal communications or ISM
radio wave radiated devices.
DECLARATION OF CONFORMITY:
Hereby, Zound Industries International AB, declares that this product is in compliance with the essential requirements and other
relevant provisions of Directive R&TTE 1999/5/EC and the RoHS directive 2011/65/EU. For the declaration of conformity, please
visit the following website: http://www.marshallheadphones.com.
For any questions or concerns contact
support@marshallheadphones.com
Zound IndustriesInternational AB • Centralplan 15 • 111 20 Stockholm • Sweden
This symbol indicates that this product shall not be treated as household waste. Instead it shall be handed over to the applicable
collection point for the recycling of electrical and electronic equipment. This product was produced after Jan 1 2006.
To prevent possible hearing damage, do not listen at high volume levels for long periods. WBCV – Monitor Bluetooth®: 113 mV
Marshall is a trademark of Marshall Amplification Plc. Permission granted. Design of product and packaging are intellectual properties of Zound
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for Marshall Monitor BT at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of Marshall Monitor BT in the language / languages: All languages as an attachment in your email.
The manual is 3,29 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
The manual is sent by email. Check your email
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.
