442779

Marshall Haze MHZ15, MHZ40C Manual

4
Zoom out
Zoom in
Previous page
1/7
Next page
54
WARNING!: RISK OF HAZARDOUS ENERGY
AVIS!: ENERGIE ELECTRIQUE DANGEREUSE!
HT Fuse
T500mAE 250V FootswitchReturn
Emulated
Line Out Send
Connect speakers before use
Output: 40 Watts RMS
Speaker Outputs
8 Ohm16 Ohm
Effects Loop
On / Off
1 2 3 4 5 6 7 8
Haze 40 Watt combo rear panel
1.MainsInputSocketwithMainsFuse
Yourampisprovidedwithadetachablemains(power)lead,
which is connected here on the rear panel – see ‘The Basics’
section at the start of this handbook for more information.
2.HT Fuse
The correct value of this H.T. fuse is specified on the rear
panel of the amplifier. NEVER attempt to bypass the fuse or fit
one of the incorrect value!
3.EmulatedLineOutSocket
The amplifier’s output processed through a speaker cabinet
emulator is made available at this connector. Use this socket
to connect your amp directly to a PAmixer or recording
equipment.
4.SpeakerOutputs
WARNING! Never use the amplifier without a load (speaker
cabinet/s) attached!
There are 2 speaker outputs available on the rear panel. They
are labelled according to the intended impedances:
16 Ohm: connect any 16 Ohms guitar cabinet to this jack.
Also used for the internal speaker.
8 Ohm: connect any 8 Ohms guitar cabinet to this jack.
WARNING: Although there are 2 speaker outputs, never
attempt to connect speakers to more than one socket at any
time. The safe combinations are 1x16 Ohm or 1x8 Ohm only.
Any other speaker configuration may stress the power
amplifier section and in extreme cases may lead to valve
and/or output transformer failure.
ALWAYS ensure you use good quality speaker (unshielded)
cables. NEVER use guitar (shielded) cables.ALWAYS use a
non-screened Marshall approved speaker lead when
connecting an extension cabinet to these units.
5.EffectsLoopSwitch
When ‘out’ this switch completely bypasses the circuitry
involved in the effects loop. Push this switch in to enable the
loop.
Note: If this switch is accidentally pushed in and there is
nothing plugged in to the loop, the signal will still pass through
from send to return by means of an internal link on the
switching jacks. This link is disconnected when something is
plugged into the return socket. The send socket has no effect
on the status of the internal link and could therefore be used
as a line out to a tuner for example if no external FX are
connected.
6&7.FX Loop-Send& Return
The FX Return socket (6) on the rear panel is used to connect
the OUTPUT of the effects processor or pedal you are using
in the effects loop. The FX loop is series and set at instrument
level so both guitar FX or professional units can be
connected. The FX Send socket (7) on the rear panel is used
to connect to the INPUT of the unit you are using in the effects
loop.
8.Footswitch
Connect the supplied 2-way footswitch here. The footswitch
enables you to change the channels, Normal or Overdrive,
and globally turn the effects on and off.
Note: When the 2-way footswitch is connected the front panel
channel switch will not function.
The optional extra 4-way footcontroller (not supplied)
PEDL-10049 expands the functionality of the Haze amplifier.
Four footswitches enables you to select between normal and
overdrive channels, switch between overdrive and overdrive
boost, enable / mute the internal reverb and enable / mute the
internal effects.
Four status LEDs reflect the current status of the amplifier –
channel, boost, reverb and effect.
Mute settings are stored per channel rather than globally
applied.
Power (RMS) 40W
Speaker Output 1x 16 Ohm / 1x 8 Ohm
Pre-Amp Valves 3x ECC83
PowerAmp Valves 2x EL34
Channels 2
Boost Switch ✔
Bright Switch ✔
Reverb ✔
Effects ✔
Footswitch 2 way supplied
Main Guitar - Input Impedance 1MΩ
Dimensions (mm) W, H, D 590 x 486 x 254
Weight (kg) 20.3
MHZ40C Combo Technical Specification
ENGLISH
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Marshall Haze MHZ15, MHZ40C at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Marshall Haze MHZ15, MHZ40C in the language / languages: English as an attachment in your email.

The manual is 1,52 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info