38776

Marquant MPR51 Manual

4
Zoom out
Zoom in
Previous page
1/6
Next page
Use Type 1 (normal) tapes only.
PLAYING BACK A TAPE
1 Set to TAPE.
2 Press STOP/EJECT to open the cassette
holder and insert a tape with the exposed side down and
the side to be played facing out.
3 Press PLAY to start play.
4 Turn VOLUME and BBS to adjust the sound.
STOP/EJECT - Stops play.
PAUSE - Pauses play. To resume play, press again.
F FWD/ REW - Fast forwards/rewinds. To stop
winding. press STOP/EJECT.
function switch
H TAPE OPERATION
G KARAOKE
RECORDING
1 Insert a tape with the side to be recorded facing out.
Wind the tape to the point where recording starts.
2 Get ready to record from the source.
To record from a CD: set function to CD and start play.
To record from the tuner: set function to RADIO and
tune to a station.
To record from built in MIC: set function to TAPE
3 Press REC to start recording.
PLAY is pressed simultaneously.
To stop recording, press STOP/EJECT.
To erase a recording, set function to TAPE and start
recording.
To turn off the unit, set function switch to TAPE.
To listen with the headphones, connect headphones with a stereo mini plug to the PHONES jack.
If an erroneous display or malfunction occurs, disconnect the AC cord and remove all the batteries
to turn off the display. Then turn the power back on.
I GENERAL
COPYRIGHT
Please check the copyright laws relating to recordings from disc, radio or external
tape for the country in which the machine is being used.
Tuner section
Frequency range, FM: 88~108MHz
AM: 540~1600KHz
Deck section
Track format- 4 track, 2 channels / Frequency range-
Normal tape / Recording system ,AC bias /Erasing
system-Magnet erase / Heads- Recording / playback
head , Erasure head
CD player section
Disc- Compact Disc- CD/MP3/Scanning method
-Non-contact
optical scanner (semiconductor laser)
J SPECIFICATIONS
General
Speaker- 78 mm full-sound (2),120 mm woofer (2) /
Output-Headphones jack (stereo 3.5mm),karaoke jack
(mono 3.5mm) / Power output- 3.5W+3.5W (10%THD)/
Power requirements- DC 15 V using ten size D batteries,
DC jack in: DC 12~15V/1.5A, AC 230V, 50Hz / Weight -
5Kg (excluding batteries) /
Dimensions - 560(W)x208(H)x226(D) mm
Accessory- AC cord (1).
Specifications and external appearance are
subject to change without notice.
1 Set function to RADIO.
2 Select a band with the BAND switch.
3 Tune to a station with TUNING control.
4 Turn VOLUME and BBS to adjust the sound.
NOTE: BBS is a base boost function.
For better reception - Extend the FM antenna and adjust
it for the best reception; AM antenna is inside the unit.
Position the unit for the best reception.
FM /FM ST
Sets the FM sound to stereo or monaural.
F TUNER OPERATION
FM ST: Reception is stereo.
FM: When an FM stereo broadcast contains noise,
set to FM. Noise is reduced, although reception is
monaural.
NOTE
If the unit picks up noise from other electrical appliances
nearby, like a TV or fluorescent lights, move the unit away.
1 Microphone plug diameter is 3.5mm.
2 Connect the microphone to microphone socket for karaoke.
IMPORTANT
Make sure that f is set to TAPE before connecting
the AC cord or inserting batteries.
CAUTION
Use only the supplied AC cord. Use with other cords may
result in the risk of fire.
Using on batteries
Open the lid of the battery compartment on the rear and
unction
C POWER SUPPLY
The batteries need to be replaced when:
The tape speed slows down, volume decreases, or
sound is distorted during operation.
notes on batteries
Do not mix different types of batteries or old batteries
with new ones.
Never recharge the batteries, apply heat to them or
take them apart.
Remove dead batteries.
If liquid leaks from the batteries, wipe thoroughly to remove.
D MAINTENANCE
To clean the cabinet
Use a soft cloth lightly moistened with mild detergent
solution. Do not use strong solvents such as alcohol.
benzine or thinner.
To clean the heads and tape paths
After every 10 hours of use, clean the Recording
heads and Playback head , the pinch roller and
capstan .Use a cotton swab 5 slightly moistened with
cleaning fluid or denatured alcohol.
Cassette tapes
To prevent accidental erasure, break off the plastic tabs
on the cassette tape after recording with a screwdriver
or other pointed tool.
To record on the tape again, cover the tab openings with
adhesive tape, etc.
E CD OPERATION
insert ten (size D) batteries, not supplied, with the and
marks correctly aligned. then close the lid.
To switch from AC power supply to battery power supply,
disconnect the AC cord from the AC inlet.
CD/MP3 OPERATION
1.Set function switch to CD position.
2.Open the disc compartment and place the disc, close
the compartment and the disc will start playing
automatically.
3.Press PLAY/PAUSE to control PLAY/PAUSE mode,
, to shift between play and pause.
4. .
Press repeatedly
Turn Volume knob to adjust the sound volume
(SKIP UP) (SKIP
UP)
(SKIP DOWN)
(SKIP DOWN)
(SKIP UP)
(SKIP DOWN)
5.Press to play next track, hold
to fast forward search the current track.
6.Press to play previous track, hold
to fast backward search the current
track.
7.Press STOP key to stop playing.
8.Press MODE to select the repeat mode when playing
a CD disc. ( REP RND NORMAL)
9.Press MODE to select the repeat mode when playing
MP3.When the player is stoped in MP3
mode, press and hold the MODE key for 3 seconds to
enable selection of folders,presss or
to select the folder, the LCD flickers.
Then press MODE.( REP ALBUM RND
NORMAL) then press PLAY.
REPEAT
Press REPEAT once- the indicator lights up and flash:
A single track is played repeatedly. Select a track
with or .
Press REPEAT twice- the indicator lights up:
All tracks are played repeatedly.
PROGRAM
In stop state, press PROGRAM and use skip/search
to select the track repeat until done then press play to
start program play. the programme memory is 99 tracks.
Batteries
Remove batteries when the appliance is not to be used for a long time. Batteries left in equipment
may cause damage through deterioration and corrosive leakage, invalidating the guarantee.
To protect the environment please use local recycling facilities for battery disposal.
Important Safety warnings
To prevent electric shock, do not remove any cover.
If anything goes wrong, don't try and fix it yourself, get a qualified service agent to look at it.
Do not expose this equipment to dripping or splashing or place any objects filled with liquids,
such as vases, on the equipment.
Never put a naked flame source on or near the equipment.
Never operate the equipment while driving a vehicle.
NOTE
Do not use irregular shape CDs(example: heart-shaped,
octagonal ones). It may result in malfunctions.
Do not place more than one disc in the disc
compartment.
Do not try to open the disc compartment during play.
Do not touch the lens. Doing so may cause malfunctions.
Press and hold the PROG button to cancel the programming.
GB-3 GB-4
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Marquant MPR51 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Marquant MPR51 in the language / languages: Dutch as an attachment in your email.

The manual is 1,65 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Marquant MPR51

Marquant MPR51 User Manual - Dutch - 3 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info