613361

Marmitek MegaView 61 Manual

6
Zoom out
Zoom in
Previous page
1/44
Next page
6 © MARMITEK
6. FREQUENTLY ASKED QUESTIONS
Bad (or no) image and sound
• Ensure that the CAT5e/6 cables are connected correctly between the MegaView60/61
transmitter and receiver (CAT5e-1 to CAT5e-1 and CAT5e-2 to CAT5e-2).
• Check if the A/V device is switched on.
• Use only CAT5e/CAT6 cable as specified in chapter 3 (CAT5e Cable Requirements).
• Check if the CAT5e/CAT6 cable provides a solid connection (no cable faults).
• Check if the RJ-45 has been connected according to the EIA/TIA T568B standard. Please
refer to attachment page 39
• Please ensure that the maximum cable length is not exceeded.
• Install your system as far away from any RF sources (wireless devices) as possible.
• Set a low resolution on your HDMI source. The CAT5e/6 cable used probably cannot deal
with the higher resolution bandwidth.
Bad (or no) infrared return signal (MegaView61)
• IR Receivers have a reception sensitivity of approx. 6 meters at a 90 degrees angle of
aperture. Range is also dependent on the remote control used.
• Check if the power adapter has been connected to the MegaView61 transmitter
• Please ensure that the IR receiver and the IR extender cable have been connected properly
and that they are fully plugged in.
• Please ensure that the LEDs of the IR extender cable are placed correctly to the infrared
sensor of the A/V device, this has to be done very precisely. The exact position can be
found easily by shining at it with a flashlight.
If none of the options above offers the solution, your remote control probably uses a different
infrared frequency. Instead of the standard 38 kHz receiver you can also order a 56 kHz
receiver (art. no. 09883).
Do you have any questions that are not answered above?
Please check www.marmitek.com.
… 6 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Marmitek MegaView 61 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Marmitek MegaView 61 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 0,61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info