12 MARMITEK
7. Repeat steps 5 and 6 for every button you want to learn.
8. When you have finished learning the buttons, press SETUP (9)
Erasing the commands learned per mode to clear memory space
You can erase the commands learned and saved for each separate function
(TV, VCR, etc.):
1. Keep the SETUP (9) button pressed until one of the Mode LEDs stays lit. Release the
SETUP (9) button.
2. Press the Mode button of your choice (TV, VCR, etc.). The LED will flash once.
3. Press the LEARN (3) button twice.
4. Press SETUP (9). The LED will extinguish after a few seconds.
5. All commands learned and saved for the selected function have now been erased.
4.6 Setting the standard volume for the satellite
receiver
The volume for the SAT mode is controlled via the TV by default. Some satellite decoders
have their own volume control. You can program this function in such a way the volume
can be controlled directly via the satellite receiver.
1. Press the TV button (2) and release it. The remote control has to be set to TV mode
for this procedure.
2. Press SETUP (9) and keep this button pressed until one of the Mode LEDs stays lit.
3. Release SETUP (9).
4. Press ‘ Mute’ (5) and keep this button pressed, The LED will extinguish.
Keep the button pressed for about 8 seconds, until the LED starts flashing.
5. The volume can now be controlled via the satellite receiver.
Repeat this procedure if you want to return to normal volume control via the TV.
4.7 Home Theatre Macro Function
Your remote control has three Macro buttons: M1, M2 and M3. You can program these
buttons to execute a series of commands with one press of a button. This powerful fea-
ture is ideal for switching on all your audio and video equipment at once or for selecting
certain preferences in Home Theatre applications.
Programming the Macro buttons M1, M2 and M3
1. Keep the SETUP (9) button pressed until one of the Mode LEDs stays lit. Release the
SETUP (9) button.
2. Press MACRO (25). The LED will flash once.
3. Press the Macro button you want to set (M1, M2 or M3).
3. Press the buttons on the remote control you want to enter under the Macro button
(maximum of 10 commands). The buttons will be executed by the macro in the same
order as they are programmed.
4. To save the macro, you press the MACRO button again. If you have used up the
maximum of 10 commands, the procedure will stop automatically and the 10
commands will be saved under the Macro button you are setting.
