6588
18
Zoom out
Zoom in
Previous page
1/79
Next page
ENGLISH
15
HDMI JACK
This SR7001 has four HDMI inputs and one HDMI
output (The SR8001 has two HDMI outputs.). It can
send digital video and audio signals from DVDs and
other sources directly to a display. It minimizes signal
degradation caused by analog conversion so that high
quality images can be enjoyed.
The SR7001 is also capable of converting analog
video signals (Composite Video, S-Video, Component
Video) for HDMI output.
Select an input source from the OSD menu system.
(See page 25, 36)
Notes:
• When the HDMI output is connected to a display
monitor that does not support HDCP, signals are not
output. To view images in HDMI, it is necessary to
connect to a display that supports HDCP.
• There may be no image output if connected to a
TV or display that is not compatible with the above
format.
Refer to the instruction manual of the TV or display to
be connected to the SR7001 for detailed information
regarding the HDMI terminal.
* HDCP: High-bandwidth Digital Content Protection
CONNECTING HDMI DEVICES
An HDMI cable (sold separately) is used to connect the
HDMI jack on the SR7001 with the HDMI jack on a DVD
player, TV, projector or other component. To transmit
multichannel audio via HDMI, the connected player
must support multichannel audio transmission through
its HDMI jack.
HDMI video streaming is compatible with DVI in
principle. Therefore, it is possible to connect to a TV
or monitor that has a DVI terminal using an HDMI-DVI
conversion cable or plug. When connecting to a DVI
terminal, connect the audio signal separately.
Notes:
Some HDMI components can be controlled over the
HDMI cable, but this receiver cannot control other
components this way.
• When connected to a monitor (i.e., TV, projector,
etc.) that does not support HDCP, video and audio
are not output.
DVI cables come with 24-pin and 29-pin plugs. This
receiver supports 24-pin DVI-D cables; 29-pin DVI
cables cannot connect to it.
• Some source devices such as DVD players or set
top box do not support HDMI repeater operations
like those of the SR7001. In such case, pictures are
not properly projected on monitors such as TVs and
projectors.
DVD player VIDEO PROJECTOR
• When multiple components are connected to this
receiver, turn power to unused components off to
prevent interference between them.
Disconnecting or connecting cables with the power
on can damage the equipment. Turn the power off
before disconnecting or connecting cables.
Some DVD-Audio disks disable downmixing.
These types of disks are not played back correctly
unless the left, center, right and surround left and
right speakers, and subwoofer are connected.
• If a DVD player that does not support HDMI 1.1
is connected to the SR7001, multi channel PCM
playback is not possible even with DVD-Audio
disks.
If an Super Audio CD player that does not support
HDMI 1.2 is connected to the receiver, DSD
playback is not possible even with Super Audio
CD.
(*DSD: Direct Stream Digital)
• If a DVD player or other device with DVI output
is connected to the SR7001, a separate audio
cable (optical-digital, coaxial digital or analog) is
needed for the audio signals. In this case, select the
connected audio input as explained in “1-1 FUNC
INPUT SETUP”. (See page 25)
Multi channel PCM signals and audio signals of 62
kHz or higher that are input from the HDMI jack are
not output from the DIGITAL OUT jacks.
• Depending on the quiality of the cable used, the
HDMI signal may be affected by noise.
COMPONENT
VIDEO
IN OUT
S-VIDEO
IN OUT
2
1
SLL
RSR
FLASHER
IN
IR
RECEIVER
IN
SPEAKER
SYSTEMS
OUT
6
COAX.
3
54
21
SURROUND
BACK
OUT
R
OUT
LTAPE CD/CDR
ON
OFF
OUTIN
MULTI OUT
R
OUT
L
DSS/VCR2
AUDIO
TV
IN
OPT.
IN
OUT
INOUT
IN
SR
VCR1
ININ
DVD SL
C
B
/
P
B
C
R
/
P
R
C
R
/
P
R
C
R
/
P
R
C
B
/
P
B
C
B
/
P
B
YYY
SBR
SBL
SBR
SBL
C
SW
SW
C
R
L
R
L
R
R
R
L
LL
1
2
EMITTER
OUT
AB
UNSWITCHED
1.25A 150W MAX
AC OUTLETS
120V 60Hz
SWITCHED
1.25A 150W MAX
VIDEO
FM
(
75
)
GND AM
ANTENNA
OUT
PUT
1
OUT
PUT
2
INPUT 3
(
VCR1
)
OUTPUT 1 OUTPUT 2INPUT 1
(
TV
)
INPUT 1
(
TV
)
INPUT 4
(
DSS/VCR2
)
INPUT 3
(
VCR1
)
INPUT 4
(
DSS/VCR2
)
INPUT 2
(
DVD
)
HDMI
Ver1.2
INPUT 2
(
DVD
)
DC OUT
PRE
OUT
DIGITAL IN
DIGITAL OUT
RC-5 MULTI RC
7.1CH
IN
MONITOR
OUT
DVD
(
2
)
DSS/VCR2
(
4
)
TV
(
1
)
MULTI
OUT
VCR1
(
3
)
DVD
(
2
)
DSS/VCR2
(
4
)
VCR1
(
3
)
TV
(
1
)
MONI. OUT
(
AUX2
)
XM
RS-232C
MULTI SPEAKER
/SPEAKER C
SUB SPEAKER
FRONT A OR B.CENTER.SURR.
SURR BACK : MINIMUM 6 OHMS
FRONT A + B : MINIMUM 8 OHMS
FRONT
B
SURR.
CEN
TER
FRONT
A
MODEL NO. SR8001
AC IN
XM
OUTPUT 1
OUTPUT 1
INPUT 4
INPUT 4
(
(
DSS/VCR2
DSS/VCR2
)
)
INPUT 2
INPUT 2
(
(
DVD
DVD
)
)
HDMI
HDMI
Ver1.2
Ver1.2
HDMI OUTPUT HDMI INPUT
HDMI OUTPUT
SATELLITE TUNER
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Marantz SR-8001 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Marantz SR-8001 in the language / languages: English as an attachment in your email.

The manual is 3,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info