Manual Marantz SR-6200 (page 20 of 31) (English)

6580

Zoom out

Zoom in

1/31

ENGLISH

SPEAKERS SETUP

The home theater system you already have installed should function

provided that there are left, center and right front speakers, left and

right rear/surround speakers and a subwoofer. For best results we

recommend that all front speakers be of the same type, with identical

or similar driver units. This will deliver smooth pans across the front

sound stage as the action moves from side to side.

Your center channel speaker is very important as over 80 % of the

dialog from a typical motion picture emanates from the center channel.

It should possess similar sonic characteristics to the main speakers.

Surround channel speakers need not be identical to the front channel

speakers, but they should be of high quality.

The surround center speaker is useful for playback of Dolby Digital

Surround EX or DTS-ES. One of the benefits of both Dolby Digital

(AC-3) and DTS is that surround channels are discrete full range,

while they were frequency limited in earlier “Pro Logic’ type systems.

Bass effects are an important part of home theater. For optimal

enjoyment a subwoofer should be used as it is optimized for low

frequency reproduction. If you have full range front speakers,

however, they may be used in place of a subwoofer with proper setting

of the switches in the menu system.

If possible, mount the surround speakers on the walls to the sides of

the viewing area, 2-3 feet above seated viewers, firing straight across

at each other.

SPKR SETUP 1/3 (SPKR SIZE)

SETUP: Select “LOCKED” with or button in order to lock the

contents of the SPKR SET UP MENU.

When you want to change the contents of this setup, select

“UNLOCKED”.

SPKR SIZE

This menu enters the information about which type of speakers will be

used for each channel.

In turn, these settings will determine which speakers receive low

frequency information.

For the purpose of establishing proper bass reproduction, use the

LARGE settings if the speaker being used at any position is a

traditional full-range loudspeaker that is capable of reproducing sound

below 100 Hz and you are not using a subwoofer.

Use the SMALL setting for smaller, frequency-limited speakers that are not

able to reproduce sounds below 100Hz and you are using a subwoofer.

Low frequencies will be diverted from the speaker to the subwoofer.

Note that when “small” speakers are used it is advisable to install a

separate subwoofer, especially if you wish to appreciate the full

impact of a good home theater soundtrack.

If the Surround speakers or Center speaker will not be used, set

NONE for each speaker. The NONE setting will send the audio for the

channel to other speakers.

FRONT -L/R : Select the type of front speakers with or button.

CENTER : Select the type of center speaker with or button.

SURR-L/R : Select the type of surround speakers with or button.

SURR.CENTER : Select the surround center speaker YES or NO with

or button.

SUBWOOFER: Select the subwoofer speaker YES or NO with or

button.

Notes:

The SUBWOOFER cannot be set to NO when the front speakers

are set to SMALL.

This speaker size setup is not effective when the SOURCE-

DIRECT or 7CH. Input is selected.

SPKR SETUP 2/3 (SPKR DISTANCE)

Use this parameter to specify the distance of the speaker’s position

from the listener.

The delay time is automatically set according to these distances.

UNITS:You can select Meters or Feet.

If you select “ft”, the setting parameter will change in 1 foot

steps.

If you select “m”, it will change in 0.3 meter steps.

Select speaker with or button, and input each speaker’s

distance with or button.

When the input for each speaker’s distance has been finished,

move the cursor to ENTER and press the OK button.

NOTES :

If your selection(s) are out of range, the distance cannot be stored.

Placement beyond that distance is beyond the range of the

automatic time delay feature.

The delay feature does not function in the SOURCE-DIRECT ,7

CH-Input modes and decoding of 96 kHz sources.

SPKR SETUP 3/3 (SPKR LEVEL)

SPKR LEVEL

TEST MODE: Selects the mode for generating the test tone.

If you select AUTO, the test tone will be cycled through

in a circular pattern which is Left → Center → Right →

Surround Right → Surround Center → Surround Left →

Subwoofer → Left → ... 3 seconds for each channel.

If you select MANUAL, press the OK button to select the

test tone channels after the “TEST TONE ON”.

TEST TONE: Press the or button, ON is indicated and the test

tone starts from the front L-CH speaker.

Press the or button again on this item. OFF is

indicated and the output of the test tone will stop.

Channel: Adjust the level of test tone for each channel with the or

buttons of the RC6200SR. The current volume level is

shown at the center of the display.



SUB WOOFER

LEFT

CENTER

RIGHT

SURROUND-L

SURROUND-R

SURROUND CENTER

Can I Program the bass an treble an volume on each chanel with out the remote control Submitted on 16-4-2021 at 12:47
Reply Report abuse

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Marantz SR-6200 in the language / languages: English as an attachment in your email.

The manual is 4,88 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Marantz SR-6200 Manual

Product: