522805
16
Zoom out
Zoom in
Previous page
1/44
Next page
6
ENGLISH
REAR PANEL CONNECTIONS
All connections to the rear panel should be made with the entire
system powered off.
To avoid errors, it is advisable to connect one cable at a time between
the various components.
[1] PHONO input / GND (GROUND)
terminal
Connect directly when the cartridge is MM (Moving Magnet) type.
Use the Step-up transfomer when the cartridge is MC (Moving Coil)
type.
And connect the grounding wire fom the Analog turntable to this
terminal.
[2] Three analog audio inputs
CD, TAPE/TUNER, and CD-R/MD :
Connect the audio outputs of your source components to the input
jacks on the amplifier.
[3] Two analog audio outputs for audio
source equipment
TAPE/TUNER and CD-R/MD :
Connect each output to the audio inputs (REC in) of your recording
equipment.
[4] Five analog audio inputs for video
source equipment
TV,LD,DVD, VCR1, and DSS/VCR2 :
Connect each input to the audio outputs of your video source
equipment.
[5] Two analog audio outputs for video
source equipment
VCR1, and DSS/VCR2 :
Connect each output to the audio inputs (REC in) of your video
recording equipment.
[6] Five video inputs
TV, DVD, VCR1, and DSS/VCR2 :
Connect each input to the video outputs of your video source
equipment.
[7] Five S-video inputs
TV, DVD, VCR1,and DSS/VCR2 :
Connect each input to the S-video outputs of your video source
equipment.
This unit's S-VIDEO input jacks support the S2 type. For details on
the screen mode of the wide-screen TV set that is connected
depending on the type of the external component's video system,
refer to the User Guide of the playback component and TV set which
are connected. These inputs are completely interchangeable with
the conventional S-VIDEO inputs.
[8] Two video outputs
VCR1, and DSS/VCR2 :
Connect each output to the video input (REC in) of your video
recording equipment.
[9] Two S-video outputs
VCR1, and DSS/VCR2 :
Connect each output terminals to S-video input (REC in) of your video
recording equipment.
[10]Two Component-video inputs
DVD, DSS,/VCR2 :
Connect the Y/Cr/Cb component video output of each your video
product to these jacks.
[11]Component Video Outputs
Connect these outputs to the component video inputs of a video
projector or monitor. When a source connected to one of the two
Component Video Inputs is selected the signal will be sent to these
jacks.
[12]Monitor. (VIDEO/S-VIDEO) output jacks
Connect this jack to the composite or S-Video input of a TV monitor or
video projector to view the on-screen menus and the output of any
standard video source selected by the receiver’s video switcher.
[13]Main Amplifier Inputs:
Connect the pre-output jacks of your pre-amp to these jacks at the
SEPARATE position of the system setup 1/2.
[14]Preamp Outputs (L, R, SL, SR, SBL,
SBR, C)
These jacks may be connected to an external power amplifier.
[15]SUB WOOFER output jack
Connect to the input jack(s) of the power amplifier for subwoofer
channel or powered subwoofer.
[16]6 CH INPUT jacks
Connect to the outputs of an external multichannel decoder or DVD
player with multichannel decoder.
[17]Six DIGITAL inputs
Dig.1,2,3 (coaxial) and Dig.4,5,6 (Optical)
Connect the digital output from a DVD player, HDTV receiver, LD
player or CD player to these jacks. The signal may be either a Dolby
Digital signal, DTS signal or a standard PCM digital source.
Note :
The coaxial connections are not for AC-3 RF from an LD, If you
want to decode this type of signal, an external demodulator must
be used.
[18]Digital Audio Outputs (Optical, Coaxial)
Connect these jacks to the matching digital input connector on a
digital recorder such as a CD-R or Mini Disc recorder.
[19]REMOTE CONT. IN/OUT terminals
Connect to a Marantz component equipped with remote control (RC-
5) terminals.
[20]Speaker Outputs terminals
Connect to the left and right speakers.
[21]AC INLET
Connect the provided detachable power cord, and connect the AC
plug to an unswitched AC wall output.
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Marantz PS17 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Marantz PS17 in the language / languages: English as an attachment in your email.

The manual is 1,74 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info