522865
4
Zoom out
Zoom in
Previous page
1/16
Next page
3
ENGLISH
FRANÇAIS
DEUTSCH
NEDERLANDS
ESPAÑOL
ITALIANO
PORTUGUÊS
SVENSKA
DANSK
FOREWORD
Be sure to read this section before any connection to the mains
supply.
WARNINGS
Never expose the amplifier to rain or moisture.
Never remove the amplifier’s cover.
Never insert anything into the amplifier’s vents.
Never handle the mains lead while your hands are wet.
EQUIPMENT MAINS WORKING SETTING
This Marantz product is available in two different variations, depend-
ing on geographical area. One variation has a preset mains voltage
(230V for General Europe model and U.K. model), while the other
variation features variable voltage that can be selected using a volt-
age selector on rear panel (110V, 120V, 220V, 240V).
The voltage selector must be set for your local mains voltage before
any connection to the mains supply. If you need to change its voltage
setting, consult your dealer your local Marantz service provider.
IMPORTANT: (FOR U.K. MODEL)
This apparatus is fitted with an approved moulded 13 Amp plug.
To change a fuse in this type of plug proceed as follows:
1. Remove fuse cover and fuse.
2. Fix new fuse which should be a BS1362 5A, A.S.T.A. or BSI ap-
proved type.
3. Refit the fuse cover.
If the fitted plug is not suitable for your socket outlets, it should be
cut off and an appropriate plug fitted in its place.
If the mains plug contains a fuse, this should have a value of 5A. If
a plug without a fuse is used, the fuse at the distribution board should
not be greater than 5A.
NOTE:
The severed plug must be destroyed to avoid a possible shock haz-
ard should it be inserted into a 13A socket elsewhere.
HOW TO CONNECT A PLUG (FOR U.K. MODEL)
The wires in the mains lead are coloured in accordance with the
following code:
BLUE— “NEUTRAL” (“N”)
BROWN—“LIVE” (“L”)
1. The BLUE wire must be connected to the terminal which is
marked with the letter “N” or coloured BLACK.
2. The BROWN wire must be connected to the terminal which is
marked with the letter “L” or coloured RED.
3. Do not connect either wires to the earth terminal in the plug which
is marked by the letter “E” or by the safety earth symbol or
coloured green or green-and-yellow.
Before replacing the plug cover, make certain that the cord grip is
clamped over the sheath of the lead—not simply over the two wires.
COPYRIGHT
Recording and playback of any material may require previous con-
sent. Refer to the following for further information.
Copyright Act 1956
Dramatic and Musical Performers Act 1958
Performers Protection Acts 1963 and 1972
Any subsequent statutory enactments and orders
ABOUT THIS USER’S GUIDE
Figure numbers refer to the illustrations located at the back of this
User’s Manual. Numbers assigned to parts and controllers match
the callout numbers used inside the illustrations.
ALL UPPER-CASE BOLD type indicates the name of a connection
or controller as it is actually marked on the amplifier.
PRECAUTIONS
Note the following important precautions whenever operating the
amplifier.
SELECTING A LOCATION
Take a few moments to consider the following points before choos-
ing a place for the amplifier.
Make sure ventilation holes are not blocked or covered.
Ensure that air can circulate freely around the amplifier.
Locate the amplifier on a surface that is free of vibration.
Choose a place where the amplifier will not be exposed to inter-
ference from an external source.
Avoid excessive heat, cold, moisture, and dust.
Keep the amplifier out of direct sunlight.
Do not locate the amplifier where it will be exposed to electro-
static charge.
GENERAL SAFETY PRECAUTIONS
Never place heavy objects on top of the amplifier.
Should foreign matter or water get into the interior of the amplifier,
immediately turn it off and contact your original dealer or Marantz
service provider.
Never pull on the mains lead when unplugging the amplifier.
Grasp the plug itself.
It is always a good idea to disconnect the amplifier from the
mains supply whenever leaving it unattended for long periods
or during thunderstorms.
CONNECTIONS
(Figure 1)
CONNECTING A TUNER
Connect the output jacks of your stereo tuner to the TUNER jacks of
this amplifier.
CONNECTING A COMPACT DISC PLAYER
Connect the output jacks of your CD player to the CD jacks of this
amplifier.
CONNECTING A TURNTABLE
Connect the L (Left) output cord of the turntable to the “L”PHONO
jack of this amplifier, and the R (Right) output cord to the “R”PHONO
jack. If the turntable has a ground wire, make sure you connect it to
the GND terminal of this amplifier. The GND terminal does not need
to be connected if the turntable does not have a ground wire.
CONNECTING A TAPE DECK
Connect the IN (recording input) jacks of the tape recorder to the
TAPE OUT jack of this amplifier, and the OUT (playback output)
jacks of the tape recorder to the TAPE IN jack.
CONNECTING A PROCESSOR
Connect the IN jacks of the processor to the PROCESSOR OUT
jack of this amplifier, and the OUT jacks of the processor to the
PROCESSOR IN jack. When not used, leave these jacks connected
with the supplied connecting pins.
CONNECTING A SPEAKER SYSTEM
You amplifier has two sets of SPEAKER SYSTEM terminals, which
means you can connect either one or two speaker systems.
NOTE:
Turn the kobes on the speaker terminals by hand. (Do not use a
tool to turn the knobs.)
Connecting One Speaker System
Note the following points when connecting a single speaker system.
The impedance of each speaker should be between 8 and 16
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Marantz PM8000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Marantz PM8000 in the language / languages: English as an attachment in your email.

The manual is 0,33 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info