Manual Marantz Model 2230 (page 11 of 19) (English)

571041

Zoom out

Zoom in

1/19

LEFT CHANNEL

COMMON

RIGHT CHANNEL

Figure 6. Stereophone Plug

STEREOPHONES

This jack accepts the standard 3-conductor phone

plug used on standard stereo headphones (see

Figure 6). It is internally connected to the power

ampl ifier section through isolation resistors to

provide adequate sound level with popular low

impedance headphones as well as with high

impedance ones. Two or more sets of headphones

may be used with the aid of "Y" connectors. The

headphone jack output is not affected by the

MAl N-SPKR-REMOTE switches.

SOME SUGGESTIONS ON USING TAPE

RECORDERS WITH YOUR MODEL 2230

There are several ways to connect and operate tape

recorders with your receiver. To avoid confusion in

the following discussion, reference to "tape

monitoring" assumesthat the recorder is equipped

with separate record and playback heads and

separate record and playback preamplifiers. To

further simplify this discussion, a tape recorder

normally connected to the rear panel facil ities will

be referred to as the "main" recorder. A separate

recorder normally connected to the front panel

jacks will be referred to asthe "external" recorder.

This general arrangement is illustrated in Figure 7.

RECORDING AND PLAYBACK

The simplest system involves only one ta.pe

recorder, whose inputs are connected to the TAPE

OUT jacks (on the rear panel) and whose playback

outputs are connected to the TAPE IN jacks. An

equally simple arrangement using the front panel

facilities involves connecting the line inputs to the

dubbing OUT jack and the playback outputs to the

dubbing IN jack.

RECORDING

To make a recording, set the selector switch to the

desired program source and put the recorder into

the "record" mode of operation. With the TAPE

MONITOR pushswitch in the "out" position, the

original program source will be heard. By depres-

sing the TAPE MONITOR pushswitch (monitor),

the "results" of the recording while it is in

progress, will be heard. A word of caution: With

the tape recorder in the record mode, be careful

not to place the selector switch in the "TAPE"

position when the TAPE MONITOR pushswitch is

"out." Doing this feeds the recorder's output

signals back to its input terminals, establishing a

reverberating loop. If the recorder's playback level

happens to be set higher than its record level, the

resulting echo or "howl" will rapidly increase in

volume level. No harm will be done to the recorder

or the receiver, but the audible effect from the

loudspeakers can be annoying.

PLAYBACK

To listen to a tape already recorded, put the

recorder in the playback mode of operation and

turn the selector switch to "TAPE". When playing

tape on an external recorder, the recorder's

playback outputs should be connected to the __

dubbing IN jack on the front panel. When playing a

tape on the main recorder, m~ke sure not~ing is

plugged into the dubbing IN Jack,.othe.rwlse the

main recorder's playback outputs Will be Internally

disconnected in the receiver.

MAKING TWO RECORDINGS

SIMULTANEOUSLY

Th is can be done by connecting two tape recorders

to the receiver, as shown in Figure 7. To monitor

the main recorder, pull the plug out of the dubbing

IN jack and depress the TAPE MONITOR push-

switch.

RECORDING A LONG-DURATION PROGRAM

With two tape recorders connected to the Model

2230 as shown in Figure 7, acontinuous recording

can be made without losing parts of the program

during reel changes. For example, with the selector

switch set to the desired program source, and the

TAPE MONITOR pushswitch in the "out" po-

sition, start the recording on the main recorder,

then prepare the external recorder to begin record-

ing before the main recorder is about to run out of

tape. As soon as the external recorder is started,

ample time will be available to reload the main

recorder in preparation for further recording. This

process can be repeated indefinitely with both

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Marantz Model 2230 in the language / languages: English as an attachment in your email.

The manual is 12,09 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Marantz Model 2230 Manual

Product: