571041
7
Zoom out
Zoom in
Previous page
1/19
Next page
shielded 300-ohm cable. (An unshielded lead-in
wire can act as an omnidirectional antenna, and
can cancel the directional benefits of your
antenna.) Low-loss 300-ohm shielded cable consists
of two inner conductors plus an outer shield and
insulating jacket. This type of shielded cable
effectively prevents the lead-in from contributing
multipath distortion.
For rural areas, it is recommended that a local
dealer be consulted about antenna installation and
lightning arrestor protection. Master antenna
system are not recommended for use with your
Model 2230; such systems are usually designed
expressly for television reception and frequently
suppress FM signals before distribution. In
addition, master antenna systems often severely
limit good quality FM reception.
~
I ,
, ,
FM ANTENNA
FM ANTENNA
3000 UNSHIElDED ~
TRANSMISSION LINE , ,
(TWIN LEAD) ::
FM ANTENNA
SINGLE WIRE
~
I I
, ,
, ,
AM ANTENNA
Where outdoor antennas are proh ibited or
inconvenient, use a simple form of 300-ohm, TV
"rabbit ear" antenna or the simple ribbon-type
folded dipole antenna supplied with the Model
2230. Both are practical and will give satisfactory
results in primary signal areas. Your Model 2230
Receiver will accept either a 75-ohm or 300-ohm
antenna. (See diagram Figure 3.) The 30().ohm
antenna cable should be connected to the two
terminals marked FM on the ANTENNA terminal.
When using 75-ohm coaxial antenna cable, connect
its shield to the "G" (GROUND) terminal, and its
inner or center conductor to either of the FM
terminals.
(Note: Close inspection of standard zipcord will
reveal some form of coding on the insulation, e.g.,
ridge or groove on one edge, one of the wires may
be "silver" while the other is bare copper.) Coded
wires help insure identical connections for each
channel.
For each channel, the coded wire can be connected
between the "common" terminal of your
loudspeaker and the GROUND terminal of the
amplifier channel. The remaining uncoded wire is
then connected between the remaining loudspeaker
and amplifier terminals. This insures correct
polarity or phasing of identical loudspeakers.
If there is any doubt about phasing of loudspeaker
pairs, or if they are not identical loudspeakers, a
simple listening test can verify correct phasing.
With program signals fed to both channels, and
with the MONO pushswitch depressed, the sound
should appear to originate at a point midway
between the loudspeakers, with the balance control
centered. As the balance control is turned away
from the center position, the sound source should
appear to move toward one of the loudspeakers.
Room acoustics can sometimes make this test
ambiguous or confusing. If so, temporarily move
the loudspeakers asclose together aspossible. Then
set the controls for balanced MONO operation and
listen to program material with strong bass pass-
ages. Reverse the wires to one of the loudspeakers
and Iisten to the same passageagain. If there is
noticeably less bass with this reversed connection,
change the connections back to the original ar-
rangement. If there is noticeably more bass, leave
the wires connected in reverse.
These phasing procedures should be used with each
stereo pair of loudspeakers, whether MAIN or
REMOTE. If both pairs of loudspeakers are used in
the same listening area, ensure that the MAIN
pair is also "in phase" with the REMOTE pair.
CAUTION:
NEVER DIRECTLY CONNECT THE lOUD-
SPEAKER TERMINALS OF ONE CHANNEL
IN PARAllEL WITH THOSE OF ANY
OTHER. ANY RESULTING DAMAGE IS
NOT COVERED UNDER WARRANTY.
Figure 3. FM/AM Antenna Connection
FM ANTENNA
The best FM reception is obtained with a
Log-Periodic type antenna, mounted on a good
quality rotor system. For fringe areas, Marantz
recommends a Log-Periodic antenna with six or
more elements designed expressly for FM
reception. For minimum local noise and multipath
pickup by the lead-in wires, use a balanced and
~
I I I
, I I
. ,
3000 SHIELDE~SHIELO
TRANSMISSION LINE ~
~
, ,
I :
750 COAX ~
TRANSMISSION SHiElD
LINE .....
4
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Marantz Model 2230 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Marantz Model 2230 in the language / languages: English as an attachment in your email.

The manual is 12,09 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info