522811
11
Zoom out
Zoom in
Previous page
1/16
Next page
10
ENGLISH
FRANÇAIS
DEUTSCH
NEDERLANDS
ESPAÑOL
ITALIANO
PORTUGUÊS
SVENSKA
DANSK
TROUBLESHOOTING
Whenever you have a problem with the amplifier, check the follow-
ing points before requesting service. What may seem to be a serious
malfunction is often the result of a simple operational error. If you
still have problems, contact your original dealer or write directly to
your nearest service provider as listed on the Marantz Authorised
Service Station list.
The amplifier does not operate and indicators do not light.
1. Check to see if the power cord is correctly inserted into a power
outlet.
Indicators light, but the amplifier does not operate.
1. Check the SELECTOR and VOLUME settings.
2. Check to see if the supplied connecting pins are correctly in-
serted into the PROCESSOR IN/OUT jacks.
Sound is being produced by only one speaker.
1. Check the BALANCE setting.
2. Turn off the amplifier and switch the connections of the left and
right speaker cords. If the same speaker still does not produce
sound, it probably means that the connection cord or the speaker
itself is defective.
Considerable humming is produced when playing from a
turntable.
1. Check to see if the plugs from the turntable are properly con-
nected to the amplifier’s PHONO jacks.
2. Connect the turntable’s ground wire to the GND terminal on the
rear panel of the amplifier. If the ground wire is already
connected, try disconnecting it.
3. Check to make sure that the turntable’s phono cartridge is se-
curely attached to the tone arm.
4. Unplug the amplifier’s power cord, turn over the plug so the two
blades go into opposite holes, and plug it back in.
Cannot perform remote operation.
1. Make sure the remote control unit’s (RC8000PM) transmitter is
pointed directly as the amplifier’s remote sensor when you per-
form a remote control unit operation.
2. Check for obstructions between the remote control unit’s trans-
mitter and the amplifier’s remote sensor.
3. Check the batteries of the remote control unit.
4. Make sure there is no strong light (from a window or other source)
shining on the amplifier’s remote sensor.
5. Check to see if there is an RCA cord connected to the REMOTE
CONTROL IN jack on the amplifier’s rear panel.
CARE AND MAINTENANCE
This section describes care and maintenance that you must per-
form in order to make sure your Marantz amplifier performs at the
level for which it is designed. Be sure to unplug the amplifier from
the mains supply before any care and maintenance.
NORMAL CLEANING
The exterior of your amplifier will last indefinitely with proper care
and cleaning. For normal cleaning, wipe exterior surfaces with a
soft, lint-free cloth.
IMPORTANT:
Any of the following will mar the finish of your amplifier and should
never be used for cleaning.
Scouring pads, steel wool, abrasive powders
Harsh chemical agents (such as a lye solution)
Alcohol, thinners, benzine, insecticide, or other volatile agents.
SPECIAL CLEANING
Should it amplifier ever become so soiled that normally cleaning is
not enough, use the following procedure for cleaning.
1. Prepare a cleaning solution of one part mild neutral liquid deter-
gent and six parts water.
2. Moisten a soft, lint-free cloth in the cleaning solution and then
wring out all excess moisture from the cloth.
3. Wipe off the amplifier with the damp cloth.
4. Dry the amplifier by wiping it with a soft dry cloth.
REPLACING THE FUSE
(for variable mains voltage version)
Should the fuse blow, immediately unplug the amplifier from the
mains supply. Replace the fuse with a new one of the same type
and rating. If the fuse blows again after the amplifier is turned on,
take the amplifier to an authorized Marantz service provider.
IMPORTANT:
Using a fuse with a higher rating or slower action does not protect
the amplifier and invalidates your warranty.
REPAIRS
Only the most competent and qualified serviced technicians should
be allowed to service this amplifier. Marantz and its factory-trained
warranty personnel have the special knowledge and facilities re-
quired for the repair and calibration of this amplifier. After expira-
tion of the warranty period, repairs can be performed for a separate
charge.
Whenever you experience problems, first try to solve the problem
yourself using the troubleshooting procedures provided on this page.
If this does not work, contact your original dealer or write directly to
your nearest service provider as listed on the Marantz Authorised
Service Station list. When you write, be sure to include the model
and serial number of your amplifier, together with a detailed
description of the problem.
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Marantz 8000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Marantz 8000 in the language / languages: English as an attachment in your email.

The manual is 0,33 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info