4
2. Important! Read carefully before carrying out any work!
This control unit may only be connected and put into operation by qualified and
suitably trained specialist personnel. For the purpose of this description qualified and
suitably trained specialist personnel are persons who are adequately instructed or
supervised by qualified electricians and are thus in a position to recognize the hazards
that electricity can cause. Moreover, they must hold qualifications consistent with the
work being carried out, in particular they must
• knowledge of applicable electro-technological regulations,
• have received training in the use and maintenance of adequate safety equipment,
• as well as first aid training.
Before carrying out any cabling work, it is essential to disconnect the control unit from
the mains supply.
Observe local safety regulations!
Always lay mains cable and control cable separately!
Control voltage 24 V DC.
Before putting the control unit into operation, it is essential to ensure that there are no
persons or objects within the door's area of operation, since a number of settings set
the door in motion.
All available emergency command devices must be tested prior to
initial operation.
The door operator may only be installed with the door closed.
After installation and initial operation, those persons or their representatives
responsible for operating the door system must be shown how the door system works.
Special note for installation according to protection category IP 65:
At the very latest following initial operation, the cable with plug allowing connection
to the mains must be replaced by a direct mains connection. At the same time a mains
isolator switch must be fitted.
Non-compliance with these warning and safety instructions can
lead to bodily injury and material damage.
