742891
78
Zoom out
Zoom in
Previous page
1/84
Next page
* if closing edge safety device is installed
English / Page 78
9. Appendix
Error
Power limit
Door can only be
opended.
Door can only be
closed in dead man's
mode*
Operator starts up
then stops.
No function.
Error message
Control light MAL-
FUNCTION flashes,
error No. 10.
.
Control light MAL-
FUNCTION flashes,
error No. 15.
Control light REFERENCE
POINT does not light
up when passing the
reference point.
Control light MAL-
FUNCTION flashes,
error No. 13.
Red control light on
optosensor circuit
board does not light
up.
Control light MAL-
FUNCTION flashes,
error No. 9.
Control lights 1 - 7
flash.
Cause for error
Door operation too sluggish.
Programming switches S20 /
S20a in position OFF, but no
photocell is connected.
Wrong setting of reference
point switch.
Optosensor not connected.
Coiled cable defective.
Optosensors are not in
bottom door seal or defective.
Bottom door seal is deformed.
RPM sensor defective.
Fault in control unit.
78


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Marantec Control 145 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Marantec Control 145 in the language / languages: English as an attachment in your email.

The manual is 2,35 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Marantec Control 145

Marantec Control 145 User Manual - German - 84 pages

Marantec Control 145 User Manual - Dutch - 42 pages

Marantec Control 145 User Manual - French - 42 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info