5. Preparation for mounting
Manual for installation and operation, Comfort 211 accu, solar GB (#76810) 11
6. Installation
6.1 / 1
6.1 / 2
6.1 Preparing the drive boom
• Press the red release pin (A) as far as possible into
the red opening on the carriage.
• Pull the pull cord (B) to release the carriage.
The carriage is now unlocked and can move freely in
the drive boom.
A
A
Reference:
The release function for the carriage
is described in Section 6.6.
• Remove the red release pin (A).
Reference:
When using multi-component booms,
refer to the corresponding instruction
manual.
B
5.2 Checks
Attention!
In order to guarantee correct
mounting, carry out the following
checks before installing.
Supply package
• Check the package to ensure that all the parts are
included.
• Check that you have all the additional components
that are necessary for your particular installation
requirements.
Door
Attention!
For garages without a second entrance:
the garage door must be fitted with an
emergency release system to allow
access to the garage if a fault occurs.
If a release kit is used:
• Check that the door locks are functioning correctly.
The door locks may not be disabled under any
circumstances.
If a release kit is not used:
• Dismantle or disable the door locks.
• Check that the door to be operated fulfils the
following conditions:
- the door must be easily moveable by hand,
- the door should automatically remain in every
position into which it was moved.
