English Page 16
Please follow exactly the installation and fitting instructions in order to avoid mistakes
in installation and damages to door and door operator.
Please keep these instructions for later reference. They contain important information
regarding operational checks and maintenance work.
Following tools are required:
Combination wrench SW 10
Combination wrench SW 13
Socket wrench SW 10
Socket wrench SW 13
Screw driver, size 8
Screw driver, size 5
Phillips Screw driver, size 2
Phillips Screw driver, size 3
Masonry drill ø 10 mm
Masonry drill ø 6 mm
Metal drill, ø 5 mm
Pliers
Hack saw
Electric drill
Folding rule
O
1
Preparation
Unpack the boom and the motor unit and keep it ready for mounting.
Attention:
Before drilling, cover the motor unit with foil or cardboard.
Drilling dust and chippings can lead to malfunctions.
O
3
Pre-adjustment of travel cut-out
• Fit two stops (B) in front of sprocked wheel holder resp. chain wheel holder (A).
• For pre-adjustment of the travel cut-out install two controllers (acc. to drawing 3) to the
transmission resp. chain.
• The sides of controllers, which are chamfered, have to show to the centre of the boom.
Attention:
Pre-adjustment depends on the length of boom.
Please stick to the measures below:
boom length L: 2960 mm 3180 mm 4090 mm
distance X: 700 mm 900 mm 1700 mm
A Sprocket wheel holder / chain wheel holder
B Detent piece disconnection
C Plastic screw, diam. 4x6 - round head
O
2
