636167
11
Zoom out
Zoom in
Previous page
1/44
Next page
On completing the installation and having checked the function, the door must be locked.
If the emergency release is required, the door must first be unlocked.
After having used the emergency release, make a test run to make sure that the motor operates
the door again.
The bolt (picture 1a / position B), the metal lever (picture 1 b / position B) and the dividing bolt
(picture 1 d/ position B) in the carriage must be removed to their rear operating position.
The red disengagement pin (picture 1C/ Position G) of the flat carriage has to be pushed
back manually in direction of the arrow.
The symbols (pictograms) on the downward side of the carriage indicate the actual state
according to illustration:
Door is separated from operator.
The front edge of the movable slide bar (B) is above the arrow symbol 'lock open'.
Door is connected to operator or will be reconnected automatically after next door
travel.
The front edge of the movable slide bar (B) is above arrow symbol 'lock closed'.
Attention:
Check the function of the emergency release regularly.
Page 11
1
GB
Shortening the Bowden Cable: (If necessary)
With the door open, establish the exact length.
Remove end sleeve from the bowden cable mantle, pull the wire cable far enough back to
allow the outer mantle to be cut through at the appropriate point. Replace the end sleeve.
Push the screw nipple onto the wire cable and shorten the remaining length to approx. 50 mm.
Tip:
Before cutting through the wire cable, wrap with insulation tape to prevent the cable
from splicing.
O
6
O
7
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Marantec 313 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Marantec 313 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Swedish, Spanish, Norwegian as an attachment in your email.

The manual is 0,29 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info