793656
18
Zoom out
Zoom in
Previous page
1/172
Next page
18 ENGLISH
3. Follow the procedures below, depending on the
type of the extension wand :
NOTE: The slide-type extension wand and the ring-
type extension wand are not compatible with each
other. If you want to change the slide-type extension
wand to the ring-type extension wand or vice versa,
change the bent pipe assembly also.
For the slide-type extension wand
Shoulder the vacuum cleaner body then insert the extension
wand into the bent pipe assembly until it clicks. To discon-
nect, extract the extension wand with pressing the button.
Fig.18: 1. Bent pipe assembly 2. Button 3. Slide-
type extension wand


The length is locked when releasing the slide button.
Fig.19: 1. Slide button
For the ring-type extension wand
Shoulder the vacuum cleaner body then twist and insert
the extension wand into the bent pipe assembly. To
disconnect, twist and extract it.
Fig.20: 1. Bent pipe assembly 2. Ring-type exten-
sion wand 3. Free nozzle
NOTE: The free nozzle can be attached to the bent
pipe assembly without pipe lock directly.


length. Tighten the ring at your desired length.
Fig.21: 1. Ring
Hose hook
When you suspend the operation, the hook on the bent pipe
assembly can be used for hanging the wand on the lower belt.
Fig.22: 1. Hook 2. Lower belt

Optional accessory
CAUTION:


properly installed. Otherwise the vacuumed dust or
particles may be exhausted from the cleaner and
they may cause respiratory disease to the operator.
NOTICE: 
replace with new one. When the dust bag is
already full, empty it.
bag/dust bag full results in reduced suction power.
NOTICE:
To prevent dust from getting into the motor:

installed before use.
Do not use a broken or ripped bag.
Otherwise the motor may be broken.
NOTICE: Do not fold the cardboard at its open-

NOTICE: 
is an important component for maintaining the

bag/dust bag may cause smoke or ignition.
NOTE:
the cleaner, the front cover does not close completely.
Fig.23
1. Unlock the lever and open the dust box cover.
Fig.24: 1. Lever 2. Dust box cover
2. 
the room as illustrated.
Fig.25: 1. Slit 2. Filter bag
When using the dust bag, insert the brim of the dust bag into the slit.
Fig.26: 1. Slit 2. Brim 3. Dust bag
3.
󰀨
push the cardboard portion to the end. Make sure that the
󰀨
Fig.27: 1.2. Rim on
󰀨3. Cardboard portion of the
4.󰀨
4. Lock the dust box cover certainly.
CAUTION: -
gers when hooking the latch, and when closing
the dust box cover.
Harness cover
Optional accessory
When using the harness cover, follow the procedure
below to attach it.
NOTE: When installing the harness cover, be careful
not to make a mistake on the front and back.
Fig.28
1. Spread the harness cover on the harness.
Fig.29
2. Secure the harness shoulder straps with the hook
and loop fasteners of the harness cover. Hook the band

Fig.30
OPERATION
WARNING: Operators shall be adequately
instructed on the use of the vacuum cleaner.
WARNING: This vacuum cleaner is not suit-
able for picking up hazardous dust.
CAUTION: This cleaner is for dry use only.
CAUTION:
Always insert the battery cartridge
all the way until it locks in place. If you can see the
red indicator on the upper side of the button, it is not
locked completely. Insert it fully until the red indicator
cannot be seen. If not, it may accidentally fall out of the

CAUTION: During operation, be conscious
of the vacuum cleaner on your back. You may
lose your balance if the vacuum cleaner body bumps
against a wall or the hose is hooked by an obstacle.
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Makita VC009G at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Makita VC009G in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Turkish, Spanish as an attachment in your email.

The manual is 26.05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info