598786
4
Zoom out
Zoom in
Previous page
1/48
Next page
18. Hold power tool by insulated gripping surfaces, when performing an
operation where the cutting accessory may contact hidden wiring or its own
cord. Cutting accessory contacting a “live” wire may make exposed metal
parts of the power tool “live” and could give the operator an electric shock.
Operating the machine
Wrong use may result in damages. Therefore, the following instructions shall
always be observed:
Use stirrers recommended by the manufacturer (maximum diameter: 140 mm
(UT1401), 180 mm (UT1600) with M14 thread).
Do not overload the machine in a way that causes a standstill.
Tool change
Caution!
Do always remove the power plug before carrying out any work on the tool.
You may catch your fingers when inserting the tool. Therefore, do always wear
protective gloves when changing tools.
The work spindle of the tool is provided with a M14 internal thread.
Keep thread and front surfaces clean. Do use a SW 22 (UT 1401) or SW 27 (UT
1600) spanner to remove the stirrer and to hold up the work spindle.
Switching the machine on and off
Short-Time Operation
Starting the machine: Press on/off switch
Stopping the machine: Release on/off switch
Permanent Operation
Starting the machine: Press on/off switch and while keeping it pressed, engage
the lock button
Stopping the machine: Press on/off switch again and release it
The mixer has an electronic switch in order to regulate the speed level by
keystrokes.
It is recommended to only use it when the machine is started or stopped in order
to avoid splashing material. If the continuous mode is operated with reduced
speed, it leads to overstress because the machine is not provided with enough
cooling air and overheating will occur significantly faster.
Speed Selection
The machine is equipped with a mechanical two-speed gearbox. Select the
required speed by rotate the gear selector. The position of the lower speed is in
direction of the working spindle. Change the speed only when the machine is not
running, and support the speed-changing by slightly rotating the work spindle.
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Makita UT 1401 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Makita UT 1401 in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 0,86 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info