448701

Makita UT 120 Manual

25
Zoom out
Zoom in
Previous page
1/43
Next page
2.6 Core can be removed from the core-bit by tapping or pressing it out from behind.
Never hit the core-bit itself with a hammer, as this can damage it.
2.7 Remove blind core (no through bore) by the aid of cold chisel or similar, levering it loose
against groove wall.
2.8 At overhead drilling always use water collecting equipment so to prevent water entering
the machine. Do not attempt to protect the machine by covering as this inhibits motor
cooling and would cause burn-out by overheating.
2.9 Water collecting rings are available for all drill bit sizes. The ring is secured to the
central screw or the centering tip of the stand base. Cut the rubber gasket about 3mm
bigger than the core-bit diameter.
2.10 Always remove broken off core-bit segment(s) from the cut groove before re-
commencing any further drilling.
3. Core-Bit
3.1 Use only core-bits recommended by your local specialist supplier or manufacturer’s
agent. Follow their advice for particular application. There is no such thing as one/or
universal core-bit that can satisfactorily drill concrete, reinforced concrete, granite,
marble and (asphalt/tarmac).
3.2 A high content of rebar or very hard ballast in concrete will cause quicker blunting of
core-bit. Re-dress more often by cutting into piece of corundum grinding wheel to re-
expose diamond particles.
3.3 There is proportionate relationship between hardness of diamonds impregnated
segment material, cutting speed and abrasiveness of material being cut. Follow speed
instructions of the drilling machine. The optimum cutting speed is between 2 and 5
m/s.
3.4 Should core-bit jam or there is no progress made when drilling, check to ensure that
there is sufficient amount of diamonds present in the surface of segments. If this is not
the case, replace the core-bit.
4. Safety Switch
4.1 Check RCD (Residual Current Device) daily, following enclosed instructions. Make
sure to use it as for any submerged pump or similar where RCD or FI-Box are a must.
… 25 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Makita UT 120 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Makita UT 120 in the language / languages: English, German, Dutch, Danish, French, Italian, Spanish as an attachment in your email.

The manual is 1,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info