448548

Makita HTR 4901 Manual

11
Zoom out
Zoom in
Previous page
1/100
Next page
11
OPERATION OF THE MACHINE
፴፧ Never operate with a loose grip.
፴፧ Never touch the cutting device when starting the engine and during operation.
፴፧ Operate the Hedge Trimmer in such a manner as to avoid inhalation of the
exhaust gases. Never run the engine in enclosed rooms (Risk of gas
poisoning). Carbon monoxide is an odorless gas.
፴፧ All protective installations and guards supplied with the machine must be
used during operation.
፴፧ Never operate the engine with a faulty exhaust muffler or if it is missing.
፴፧ Use the Hedge Trimmer only in good light and visibility.
፴፧ During the winter season beware of slippery or wet areas, ice and snow.
(Risk of slipping.) Always ensure a safe footing .
፴፧ Never stand on a ladder and run the Hedge Trimmer. Keep both feet on the
ground.
፴፧ Never climb up the trees with the Hedge Trimmer to perform cutting
operation.
፴፧ Never work on unstable surfaces.
፴፧ Remove sand, stone, nails, wire, etc. found within the working area. Foreign
objects may damage the cutting blades.
፴፧ Before commencing cutting, the cutting blades must have reached full
working speed.
፴፧ Always hold the Hedge Trimmer firmly with both hands on the handles only.
፴፧ Use a firm grip with thumbs and fingers encircling the handles.
፴፧ When you release the throttle, it takes a few moments before the cutting
blades stop.
፴፧ The Hedge Trimmer must not be used for cutting with fast idle. The cutting
speed cannot be adjusted with the throttle control in fast idle position.
፴፧ When cutting a hedge, the machine should be held so that the blades form a
15-30°angle with the cutting line.
፴፧ If the Hedge Trimmer is used with circular movements against the edge of the
hedge, the twigs will be thrown directly to the ground.
፴፧ Pay special attention when cutting hedges, which are, laid out a long a
wire-fence and have grown through the fence.
፴፧ The blade must not contact the fence; otherwise the blades may be
destroyed.
፴፧ Do not use the Hedge Trimmer continuously for a long time. It is normal to
take a break of 10 to 20 minutes after every 50 minutes operation.
፴፧ Should the cutting blades hit stones or other hard objects, immediately switch
off the engine and inspect the cutting blades for damage. Replace damaged
blades before re-commencing work.
፴፧ The engine must be switched off immediately in case of any engine
problems.
፴፧ Operate the Hedge Trimmer with as little noise and contamination as possible.
In particular check the correct setting of the carburetor and the fuel/oil ratio.
፴፧ Do Not attempt to remove jammed cut material when blades are running.
Put unit down, turn it off, and remove necessary cuttings.
… 11 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Makita HTR 4901 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Makita HTR 4901 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 2,43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info