599737
43
Zoom out
Zoom in
Previous page
1/45
Next page
4
1
10-4 Engine dose not run.
Symptom Possible causes Remedy
1. Electric starter
dose not operate
1) The key switch (or remote
switch) is turned to "START"
within 2 seconds the engine has
been stopped.
Wait for more than 2 seconds and then turn the
key switch to "START" position.
1) No fuel in the tank or the fuel
cock is closed.
2) The remote controller is con-
nected.
Both the key switch of the generator and the
switch of remote controller must be turns into
"ON" position.
3) The above possible causes 1)
and 2) dose not apply.
The ECU is defective.
Replace with new one.
2. Warning lamp
turns on and off
when engine is
stopped
Supply fuel or open the fuel cocks.
2) Oil level is low or oil is contami-
nated.
Add or change engine oil.
3. Engine is auto-
matically stopped
but the warning
lamp dose not
light up
1) The bulb of warning lamp failed. Replace the bulb with a new one.
43


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Makita G12000R at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Makita G12000R in the language / languages: English as an attachment in your email.

The manual is 1,4 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info