599906

Makita EW220R Manual

26
Zoom out
Zoom in
Previous page
1/152
Next page
EN
3.
PRE-OPERATION FOR STARTING
(See Fig.
22
22
2
)
Stop the engine and open the cap.
Use automotive unleaded gasoline only.
This engine is certified to operate on automotive unleaded
gasoline.
1. CONNECT SUCTION HOSE
(See Fig.
22
22
2
-
qq
qq
q)
Use a reinforced-wall or wire braided hose to prevent suction
collapse.
Since the pump self-priming time is directly proportional to
hose length, a short hose is recommended.
Always use a strainer with the suction hose. Gravel
or debris sucked into the pump will cause serious
damage to the impeller and the pump casting.
CAUTION
2. CONNECT DELIVERY HOSE
(See Fig.
22
22
2
-
ww
ww
w)
When using a fabric hose, always use a hose band to prevent
the hose from disconnecting under high pressure.
4. CHECK FUEL
(See Fig.
22
22
2
-
tt
tt
t)
3. CHECK ENGINE OIL (See Fig.
22
22
2
-
rr
rr
r)
Before checking or refilling engine oil, be sure the engine is
located on stable, level surface and stopped.
Do not screw the oil gauge into the oil filler neck to check
oil level. If the oil level is low, refill to the upper level with
the following recommended oil.
Use 4-stroke automotive detergent oil of API service class
SE or higher grade (SG, SH or SJ is recommended).
Select the viscosity based on the air temperature at the
time of operation as shown in the table. (See Fig.2
e)
Explanation of Fig.
22
22
2
-
rr
rr
r
q Oil Gauge
w Upper Level
e Lower Level
5. CHECK PRIMING WATER
(See Fig.
22
22
2
-
uu
uu
u)
It is recommended that the water chamber of pump casing
should be primed with full of water before operating.
Never attempt to operate the pump without priming
water or the pump will overheat. Extended dry
operation will destroy the mechanical seal.
If the unit has been operated dry, stop the engine
immediately and allow the pump to cool before
adding priming water.
WARNING
Do not refuel while smoking, near an open flame
or other such potential fire hazards. Otherwise
fire accident may occur.
WARNING
Incline the engine as fuel inlet upward, then refill fuel to
the upper level. Do not fill fuel too much. (EW120R)
Close the fuel cock before filling the fuel tank.
(Except EW120R)
Explanation of Fig.3
q
q Maximum Fuel level
Do not fill above the top of the fuel filter screen (marked q),
or the fuel may overflow when it heats up later and expands.
(Except EW120R)
Reattach the fuel cap by turning clockwise until reaching
the physical stop (about one quarter turn). Do not attempt
to turn past the physical stop or the fuel cap may be
damaged. (Except EW120R)
When filling the fuel tank, always use the fuel filter screen.
Wipe off any spilled fuel before starting the engine.
(See Fig.2
y)
Fuel Tank CapacityModel
EW120R 0.5L
EW220R
EW220ST
2.7L
EW320R
EW220TR
3.6L
EW320TR 6.1L
Oil CapacityModel
EW120R 0.08L
EW220R
EW220ST
EW320R
EW220TR
0.6L
EW320TR 1.0L
… 26 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Makita EW220R at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Makita EW220R in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 5,48 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info