448401
9
Zoom out
Zoom in
Previous page
1/68
Next page
8
ATTENTION: Toujours couper le moteur et retirer le connecteur de la bougie
d'allumage avant de procéder à tout travail au niveau de la
débroussailleuse / taille-bordures.
Toujours porter des gants de protection!
ATTENTION: Mettre la débroussailleuse / taille-bordures en marche
uniquement après l'avoir assemblée complètement.
Pour les modèles à polgnée en U
Insérer la barre de la poignée dans le support de la poignée en s'assurant
que la bosse présente sur le support s'enclenche dans le trou de la poignée.
Une fois la barre de la poignée mise en place, serrer les quatre boulons (M5
x 25).
REMARQUE: S'assurer que les boulons sont serrés mais ne pas les serrer de
manière excessive.
Fixer le câble des gaz (avec le câble de terre) à la poignée à laide dun deux
clip (3).
Prendre les mesures nécessaires pour empêcher que le câble de commande
senroule autour de la barre de la poignée.
Machines à poignée simple
Fixer une barrière sur le côté gauche de la débroussailleuse avec la poignée
pour la sécurité de lutilisateur.
Ne pas approcher la poignée simple à la poignée de commande.
Maintenir la position entre la poignée simple et la poignée à plus de 250 mm.
(Un collier d’écartement est prévu à effet.)
MONTAGE DE LA POIGN
É
E
Moteur
(3)
Moteur
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Makita EM 4251 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Makita EM 4251 in the language / languages: German, Dutch, French as an attachment in your email.

The manual is 1,16 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info